Your cart is empty.
Your cart is empty.Product Description
BNC Female to Dual 4mm Banana Female Jack Socket Binding Post Adapter Connector
Black plastic, dual port Banana Jack Socket for easier recognition, screws type, no soldering.
This Banana jack look nice and provide a solid contact.
Binding posts facilitate connections of test leads or additional components.
Connections can be made to the binding posts by spade lugs, banana jack or wire leads
T. W. Moody
Reviewed in the United States on May 6, 2025
Works as it should. Would buy more if needed.
Northe K. Osbrink
Reviewed in the United States on May 20, 2025
Seems well made. Find them very useful for various test setups.
Ludd Ned
Reviewed in the United States on May 2, 2025
Seem okay for chinesium
Robert K
Reviewed in the United States on May 16, 2025
Like its "opposite gender" couins, an excellent set of binding post to bnc adapters for ham radio/straight-wire antennas.
Stan
Reviewed in the United States on May 11, 2025
For quick and simple way to build small basic dipole for low-powered VHF to extended range for your VHF up to 25 watts from BNC connector. Because of MURS are limited to out-put power 2 watts by FCC law. Good news: You'll DOUBLE the MURS range without breaking the FCC Law. Also great for VHF Aircraft, 2-Meter, VHF-High, Marine Band and 222 MHz band. Can be used for UHF-Low band as dipole to simple beam antenna as for Great experiment with low SWR for greatest range.
Bill
Reviewed in the United States on April 3, 2025
Good quality at a great price. Now I can make a couple of inexpensive yet great performing dipole antennas !
VK5LA
Reviewed in Australia on September 22, 2024
Quality item, well made, recommended
TxWorkaholic
Reviewed in the United States on July 2, 2024
Like everyone else, I used this to make a 20 meter QRP dipole antenna for my portable operations. I used a 3/16 drill bit and drilled a hole between the terminals then attached a carabiner clip to it so there would be no strain on the wire. I used about 17' of 20 gauge wire for each side and deployed for fine tuning. I was able to trim the ends to get the phone portion of the band to 1.0 SWR and the digital portion of the band to 1.2 As you can tell, it has a low Q (wide bandwidth) to cover the entire band without an antenna tuner. It would not be resonant on any other band without one. Since you get 5 to a pack, make 5 bands. Also in the picture I have a female BNC to SO239 adapter because all of my cables are RG-8X with PL-259 ends. These things are great for dipoles. Between wire, carabiner and adapter I have less than $10 in it and it works amazing and is super light weight.
amazonuser2o232
Reviewed in Canada on May 19, 2024
Easy to use for field expedient antennas. Plastic quality could be a bit better but still gets the job done reliably.
mark schmidt
Reviewed in the United States on November 16, 2024
I use them to make portable dipole and there a awesome bargain.
The Proud Whiteman
Reviewed in Canada on July 6, 2023
Ham radio antennas... This rocks
Customer
Reviewed in Canada on July 19, 2023
I use these for ham radio portable antennae, both VHF and low power HF. Connect the dipole leads to the holes in the banana sockets, and coax cables from the BNC connector to the radio. Quality of these is good. Would buy again.
Customer
Reviewed in Canada on October 13, 2022
It works good forwhat i needed
Recommended Products