Your cart is empty.
Your cart is empty.The pin chuck is a perfect accessory for holding drills too small to be held by standard a drill chuck, comes complete with three collets. Interchangeable collets of the following sizes: 0 - 0.75mm (0 - 1/32 in); 0.75 - 1.5mm (1/32 - 1/16 in); 1.5 - 2.5mm (1/16 - 3/32 in). Shank size, 6.5mm or 1/4 inch.
Anthony Levy
Reviewed in the United States on October 16, 2024
I wanted to make my daughter some stud earrings so I got some blank studs to put my own materials on them. They were very hard to hold and sand so I got these to hold them while making the earrings. They work perfectly for what I am using them for. They come very oiled to prevent rusting or sticking I assume. I did accidentally superglue one closed but it was easy to clean up.
Mr. Eltrut
Reviewed in the United States on March 9, 2023
Good quality, works good for the job of holding / using wire drill bits.
Brian J.
Reviewed in the United States on February 5, 2023
The collets have terrible burrs on them from manufacturing. And even after fixing that, the concentricity is horrendous. I put a 1/32" bit in the smallest collet, and it does 1/16" circles when you turn the motor on. Anything intended for drilling needs to have good concentricity!
Placeholder
Reviewed in the United States on January 11, 2022
This pin-vice was poorly machined and would not run true in my drill press. The smallest collet closed asymmetrically making it impossible to center a drill bit. Basically worthless. Find something better. No stars to this seller!
Customer
Reviewed in the United States on March 25, 2021
Small lathe.
Customer
Reviewed in the United States on June 29, 2020
Very happy , super handy for the tiny drill bits
britinindy
Reviewed in the United States on November 17, 2020
Collets are poorly made causing the drill bits not to run true, not even close. Spend the extra money on a properly engineered pin chuck from a bone fide machine supplier.
g.p.burdell
Reviewed in the United States on July 28, 2019
these vices can be hand held or inserted in a drill (although for small drill bits used in an electric drill will likely lead to instant breakage)!!.
Recommended Products
