Your cart is empty.
Your cart is empty.PONTOON FENDER CLIPS SOLID ALUMINUM WITH LOCKING PIN HOLDS UP TO 1/2" ROPE FITS 1 1/4" SQUARE RAILS
staceyB
Reviewed in the United States on November 3, 2022
Pin needs to be secured to prevent getting lost
Kane Riggs
Reviewed in the United States on September 28, 2021
After trying several other clamps and clips for my New Tritoon with no success i found this and it was made in America. I highly recommend this product for square railing.
JGH
Reviewed in the United States on June 26, 2021
I received these today and there’s just one problem, the rails on my 2021 Bennington are too long for the little pin to slide underneath the rail to secure these completely. They do perfectly fit over the top of them though and in case you were wondering there is a protective coating inside of these clips so they won’t scratch your rail. They just need to be made about a half an inch longer. Perhaps make them longer, put two separate holes for the pin for rails that are shorter in length and for rails that are longer. As many clips I have seen don’t have any pins to hold them 100% in place I am assuming these are going to work OK. Time will tell. I will say they are very much overpriced though.
Paul Cave
Reviewed in the United States on June 25, 2021
Everyone that sees these say they are ordering them. So easy to adjust, put on/off, and well built.
Kool bean
Reviewed in the United States on August 6, 2020
It’s not a fender holder. It’s a flag holder
Lee V
Reviewed in the United States on December 1, 2019
I have a pontoon boat, and I like these because I can easily switch what side the fenders are on, and adjust the height of the fender for different piers or boats to tie up to.
Recommended Products
