Your cart is empty.
Your cart is empty.Product Description
Powerbuilt Fuel and Brake Line Tubing Bender
The Powerbuilt Tubing Bender that works on 1/4 in., 5/16 in., and 3/8 in. (4, 6, and 8mm) pipes. It can be used on copper, aluminum, brass and steel tubing. Light weight for easy handling. Makes left, right and offset bends up to 90 degrees to create up to a 180 degree bend. Tubing bender tool has degree marking on the face for more accurate bending.
- Works on 1/4 in., 5/16 in., and 3/8 in. pipes
- Works on copper, brass, aluminum and steel
- Bends from 0 to 180 degrees
- High visibility marking
- Light weight for easy handling
Customer
Reviewed in Canada on May 13, 2025
cheap broke after a couple bendsdon't use on metal tube maybe on copper
orbitup
Reviewed in the United States on November 17, 2024
I only used it a few times and one of the pivot pins came out. POS.
Darcia
Reviewed in the United States on October 25, 2023
I use this to make a fuel line from my fuel pump to my carburetor on my classic car. It worked great for bending the 1/4” and 5/16” lines. The 3/8” line is hard to bend with the short length of the handles. I would get a tool with longer handles if I were bending 3/8” fuel line.
Steve
Reviewed in the United States on February 20, 2022
The press-fit "bolts" separated as soon as I pulled the unit out of the box. I replaced them both with better hardware, and then the mouth of the bender bent open on basic mild 5/16 steel tube.
Linda B
Reviewed in the United States on June 16, 2021
Was just what I needed.
John l holmes
Reviewed in the United States on June 14, 2021
Great value & angles are clearly marked. E-z to use.
Freddy
Reviewed in the United States on June 13, 2021
This tool broke within the first 10 minutes of use. Pure Garbage
hawaiian mike customs
Reviewed in the United States on May 22, 2021
Works great
MP220
Reviewed in the United States on December 18, 2021
Bent 3/16 and 5/16 OD NiCopp tubing for brake and fuel lines with ease. No kinks whatsoever with 3/16, which was good since the brakes are safety critical. 5/16 left a slight crush bend, which may matter if you are fabricating fuel supply lines (mine were vapor). Line up the beginning of the bend with the "O", marking the tubing with sharpie, and you should be able to replicate the lines without issue.
Recommended Products
$63.91
$ 27 .99 $27.99
$145.11
$ 64 .99 $64.99