Your cart is empty.
Your cart is empty.Tecmark Tridelta (TDI) Stainless Steel Pressure Switch for electric heaters used on spas and hot tubs, 3029. SPST, Normally Open, 25 Amp water pressure switch has two 1/4"" standard tab wire terminals, Common and NO. 1/8"" NPT water connection and case are stainless steel for durability. Tridelta/Tecmark pressure switch 3029 is a very common 1/8"" pressure switch, and fits a variety of spas and pool heaters. Also available in corrosion resistant plastic see 3029P. Note: 1/8"" NPT threads to attach the water line or to screw into heater tube or header actually measures 3/8"" OD when measured across the threads. Pressure switches are used on spa, tub and bath heaters to measure the amount of water pressure inside of the heater, as an approximation of water flow. Pressure switches are safety devices intended to prevent heater damage and overheated water hazards. If your pressure switch is causing the heater to shut down, look for causes of low flow in and out of the heater, and remove the spa filter temporarily to improve flow. Pressure switches do fail eventually (which is why sell replacements), but first assume a flow problem, and not a switch problem. Adjustable Pressure Switch comes factory set but can be adjusted from 1 to 5 psi. Pressure switches do not normally need adjustment after installation, and to avoid heater damage or overheated water, large adjustments should be avoided. 1-2 psi is the correct setting for most spas, tubs and whirlpools. High Altitude locations or spa systems located several feet Below the spa, may need 3-5 psi settings. Refer to your spa heater manual or heater documentation, for any instructions on heater pressure switch settings.
Goldpanman
Reviewed in the United States on August 23, 2024
Very satisfied. This part is a perfect match to the pressure switch that failed in our very old United Spa. It's now back to heating the water like its' supposed to.
Rebecca LaRaut
Reviewed in the United States on February 7, 2024
I have a 20 year old Hot Tub that I keep runny through aftermarket parts. This one was an exact fit and easy to install. Now for a glass of wine and a soak.
TR
Reviewed in the United States on April 2, 2024
Easy to install. It was not set to pressure from the factory. I was able to find adjustment steps on line.
Cherokee4Life
Reviewed in the United States on April 26, 2023
I have an old Hot Tub and the pressure switch was rusted to pieces (literally). I was hoping that this one (same Model # 3010) would work and it did perfectly. The moment I had it installed and turned on the HotTub it started to heat up again like it was brand new.
Robin
Reviewed in the United States on November 22, 2022
First plumped fitting that never leaked!
Customer
Reviewed in the United States on October 15, 2021
Shipped fast and was super easy to install
Paul G. Bovee
Reviewed in the United States on April 17, 2021
It does not install easyNo wrench access to tighten
Richard Rogahn
Reviewed in the United States on October 17, 2020
worked as expected
Recommended Products
$30.66
$ 14 .99 $14.99