Your cart is empty.
Your cart is empty.Polyurethane based suspension, driveline and chassis components have been designed as an upgrade to the soft factory rubber components.
Tazz408
Reviewed in the United States on September 9, 2021
Used with 4’ angled lowering blocks on a d21 , rides nicely
Joseph S. Sowden
Reviewed in the United States on August 24, 2019
These worked great on my lowered D21 pickup. Just had to open up the ends to fit the stock bolt holes and drill a half inch divot in the center to clear a bolt on the frame. Work and look great. Very easy to do and took maybe 30 mins to modify and install.
Mark AZ,
Reviewed in the United States on June 28, 2017
Great product to help those with lowered vehicles avoid rear drive axle from frame strikes. I own a 1986 Nissan D21 with a 4" drop. I required some frame clearance to axle without the need to ride on the factory bump stop. This set of low clearance bump stops did the trick. A slight modification was needed to allow factory bolts to feed through bumpstop ears. I used a 10.5mm drill bit at the end of ears. The solution was perfect i am pleased with the results.
Customer
Reviewed in the United States on September 1, 2016
Good quality product. It would be nice if they offered a few more vehicle specific products.
P. M. Schwartz
Reviewed in the United States on March 26, 2015
Overall these work as advertised. For my '05 Dodge Ram 1500, the factory bump stop mounting holes are narrower than what these are set for but with a die grinding bit and file, I was able to slot them in enough to allow me to bolt to the factory location without any mods to the truck. Based on my measurements, these are the right height for my needs and will keep from banging the axle onto the frame. Just what I needed
Recommended Products
