Your cart is empty.
Your cart is empty.Polyurethane based suspension, driveline and chassis components have been designed as an upgrade to the soft factory rubber components.
john choinski jr
Reviewed in the United States on April 25, 2021
Definitely made a difference in my suspension, but you better have some kind of press to install them. I used my ball joint press and it worked fine. Still wasn't easy but definitely worth the money!
JBB
Reviewed in the United States on February 16, 2020
1. If you do not have any experience replacing bushings, do not try this yourself. 2. These fit a 2nd generation Honda CRV if you cross reference part numbers, the same bushings are used for a Honda civic. 3. Set aside at least 4 hours to do job 4. Excellent product. Your front suspension will feel very exact.
Matt
Reviewed in the United States on November 28, 2020
Everything fits my 2002 Civic Sedan. However the kit does not match the picture. I did not receive parts for the front bushing of the rear trailing arm. The picture shows 4 of the metal rods/snap rings for the upper arm and the rear trailing arm. I only received 2 rods and snap rings for the upper rods.
Customer
Reviewed in the United States on September 30, 2016
Product worked as expected
MONKEY
Reviewed in the United States on April 4, 2012
Installed these in a 2003 civic SI. My old bushings were shot, these make the front end feel much more controlled and tight. Highly recommend for higher mileage vehicles. Although these are not for the mechanically challenged. You will need to have these pressed in and perhaps press the old ones out. Although I always use a reciprocating saw to cut the old one then hammer it out. All in all a very good product for the money and if you know what you're doing it's only a few hours or less to install.
Recommended Products
