Your cart is empty.
Your cart is empty. Description:
Duemilanove used in conjunction with ProtoShield prototype extension boards, used to build the circuit prototypes directly on the board welding components, mini bread plate above can also be connected to the circuit.
The ProtoShield prototype expansion board with two LEDs and two buttons circuit, can be used directly, pin and power have been elicited, very fit and For Arduino with the build circuit prototype.
Specification:
Small soldering area.
All pins are brought to the top level.
5V, GND, and Raw pins are exposed as well.
SOIC place for IC.
The mini breadboard has 170 tie points.
Prototype Size: 7cm x 5.5cm x 2cm. /2.8 x 2.2 x 0.8inch
Mini breadboard size: 4.4 x 3.4 x 1cm. /1.7 x 1.3 x 0.4inch
Package Included:
1 x Uno R3 Prototyping Shield Prototype Expansion Board
1 x Mini breadboard
2 x Resistor
2 x Restart Button
2 x 3mm LED
1 x 74Pin
private
Reviewed in the United States on August 16, 2024
This is really no help.There are no solderable contacts between the pins on the R3 and the board.A good definition for useless.
noah
Reviewed in the United States on June 15, 2024
Was hoping to recieve my diy shield to out together myself as I have with my diy unos having it come completely assembled kind of voided my reason for buying it in the first place. So if you see the picture showing headers and components all organized separately it's bologna the picture of the fully assembled board is what you will recieve.
schirminator
Reviewed in the United States on June 9, 2023
The board is shown not assembled but comes assembled. Connectors were soldered but not seated on the board. Non-stacking connectors so you can't mount another Arduino board on top of this one. Pretty much a throw away as fa as I am concerned. Then again, you get what you pay for, cheap!
Brien
Reviewed in the United States on June 19, 2023
I purchased this board so that I could solder connections permanantly to the various buses. Unfortunately it came with the prototype jumper connectors installed so I had to cut them off and unsolder the pins and clean the holes out so I could solder wires to the CCA. I guess I should have read the one through three star reviews before ordering, as they describe that the product is not as advertised.
Pete
Reviewed in the United States on April 14, 2022
As George Simon said, the board is depicted unassembled. I only need 1 LED, resistor, and switch installed, and the +5V and GND bus headers are in the way of my intended usage - mounting a ZIF socket on the proto board. I can unsolder the 2 headers, but would have preferred the board to be delivered unassembled. At least they didn't attach the solderless breadboard. Thanks for not much, DAOKI.
George Simon
Reviewed in the United States on September 17, 2020
DESPITE THE PICTURES AND DESCRIPTION, this proto board comes ASSEMBLED. It shows you multiple pictures of the unassembled board, tells you that package contains the board In unassembled form, but when you get it, it’s ASSEMBLED. This would have gotten five stars if they actually sold the product they said they did.I’m not going to run all over town to return a $6 board so I guess I’m stuck with this. Yet another proto board sitting in my drawer doing nothing. I’m sure I’ll need it someday (unlikely)
Recommended Products
