Your cart is empty.
Your cart is empty.Product Description
Package include:
- 1 × Brushless DC Spindle Motor ER8
- 1 × Spindle Motor Driver
- 1 × Spindle Motor Mount Bracket
104W Brushless DC Spindle Motor
Parameters:
- Output Power: 104W
- Voltage: 24V DC
- Load current:1.35 Amps Max.
- Load speed: 10800±rpm
- Rated speed: 9000±rpm
- Back EMF constant: 2.2V KPRM
- Collet: ER8
- Torque Constant: 0.021N.m/A
- Rated torque: 0.11N.m
- Phase to phase-resistance: 0.12Ohms
Wiring:
- U=Yellow
- V=Green
- W=Blue
Parameter of NBD200 Spindel Motor Driver:
- CW & CCW Control
- Speed control mode: 0-5V Analog mode and PWM mode
- Supply voltage: 24V
- Supply current: Minimum 5A
Cait
Reviewed in the United States on June 25, 2024
Didn't get around to setting it up until after the return window, so I am stuck with this piece of garbage. There is analog (5V) input and PWM mode, but no instructions on using PWM mode. The spindle never gets up to speed. It doesn't matter if there is 5V going into the analog input and the reference voltage, it will only try to start when you ground out either forward or reverse pins. It tries to spin up, then the alarm lights start to flash. The process then repeats over and over again with the spindle never getting up to speed.
Robert J Roswick
Reviewed in the United States on March 16, 2024
I rate it a 4.9. This device rarely shows up on an Amazon search for CNC spindles. It is hard to find. It needs an additional circuit diagram.
SomeGuyYouDontKnow
Reviewed in the United States on December 14, 2024
I like this little spindle, but the driver needs work. I got the spindle working via PWM, but the spindle will not turn off unless the FOR pin is in a OPEN state. I have yet to figure out how to get my GRBL controller to flip a pin from being OPEN to being ground. You can't use a TTL pin either because 5v across the FOR pin is the same as ground where both levels turn the spindle on. The only way as of right now is to install a physical switch. I want to be able to fully control the spindle via software.
Bogdan
Reviewed in the United States on November 4, 2024
The motor is small enough and quiet. With AIN control the minimum speed is 1900 RPM, maximum speed is 10400 RPM. Just do not forget to chose correct mode of controller (PWM or AIN)
Progress Ndlovu
Reviewed in the United Arab Emirates on August 11, 2023
Not happy about the collet size
Crafty One
Reviewed in the United States on June 19, 2023
Ordered this by mistake thinking it was larger. Not the fault of the seller at all and was my mistake. The item although small had some weight to it and spun smoothly. I ended up returning it for a larger spindle. However this would be perfect for a small form factor CNC machine for sure!
Alex
Reviewed in the United States on November 24, 2023
The media could not be loaded.
Jose Martin Ceja Medina
Reviewed in Mexico on October 17, 2022
En la descripción se refiere a un collet ER11, pero llegó con un collet ER8. No se ha montado aún, pero en las pruebas iniciales todo ha funcionado bien, vibración y ruido mínimos.
Recommended Products