Your cart is empty.
Your cart is empty. Specification:
Condition: Brand New
Item Type: RC Accessories
Type: Without Brake, With Brake (Optional)
Material: PCB
Size: Approx. 28 X 19mm / 1.1 x 0.7in
Forward: 30A
Instantaneous Peak: 40A
Returns: 20A
Brake: 40A
Function: Forward, Backward, Brake
UBEC Output: Voltage 5.7v, Current 1a (Power Receiver, Servo Power)
Voltage Support: 4 ~ 8v Can Be Used Directly On 2s Lithium Battery (7.4v).
Wiring:
Battery (Must Pay Dividends)
Motor (Regardless Of Positive Or Negative)
Black Red And White Third Line-> Receiver Ch2 (Usually Black On The Outside And White On The Sticker)
Regulation:
Esc Is Set In The Middle Of The Range, And New Controls Usually Require Fine-Tuning The Throttle.
Esc Is Not Lit, It Is An Intermediate Value, And The Throttle Trimming Is Controlled By Th Trim.
Compatible: For 1/16 1/18 1/24 Car And Ships
Package List:
1 x Two Way Brush ESC
Note:
1. Due to manual measurement, please allow 1-3mm error!
2. The color may be slightly different for different monitor displays.
3. By default, the JST header has a switch.
Joel
Reviewed in the United States on July 14, 2024
Couldn't get it to pull me than 10A on my setup. Then it started smoking.
Konik pearl
Reviewed in the United States on May 24, 2024
it looks good however this is not a 30 amp ESC and will turn off if you pull more than like half an amp. you get what you pay for low-quality garbage. do not buy
Eugene
Reviewed in the United States on November 4, 2024
During testing before installation, I connected it to the motor and then to the battery. It turned on the moter immediately without the reciever. Hooked the reciever up then tried to adjust the throttle trim. That didn't stop it so I hit reverse and immediately smoked the battery wires. They sold me a faulty unit and cost me time and money.
Christophe B.
Reviewed in Canada on April 3, 2024
I like how small and basic it is. I used it on 1/24 crawler and works well. I should taken no brake model. Big downside is the absent of low voltage cut off/alarm. As such i will only use it for testing but it never be the final eac on the rig. Too bad the product fall short for missing low voltage cut-off
Brielle
Reviewed in the United States on August 5, 2023
So far everything works. Can’t complain yet!
Verne
Reviewed in the United States on November 24, 2023
It could be put in a box
sarena williams
Reviewed in the United States on January 2, 2023
Was glitching brand new hard to control, ended up switching it out.
Rebecca Otto
Reviewed in the United States on June 1, 2022
I originally ordered one with a brake. Essentially, after going forward normally, when you reverse for the first time, it engages the brake instead. This is no good for a crawler compared to one that just has brake during idle.ANYWAYS, I ordered a second one without brake and the second one came ALSO with a brake. Ugh...Other than that, and if this weird mechanism is what you looking for than this is a good product. It worked normal other than the brake.
Adam Sherlin
Reviewed in the United States on May 7, 2022
Bought this for my Scx24 after I burned up the esc it came with. This thing actually might be marginally better than stock. It’s also smaller and flat, to keep your center of gravity nice and low. You just need a jst female and a jst male to pop onto the stock motor and battery leads.
Recommended Products
