Your cart is empty.
Your cart is empty.Descriptions: -RC906 is specially made for 1/10 1/14 Rock Crawler. Feature: -9 slot -6 pole with high torque --9 slot -6 pole with high torque - High Effeciency - 6 Pole brushless motor - Superior rotor design - High quality raw material - High torque and light weight - More sensitive acceleration with 9 Slots - Less Heat More Power Size: -Length:50mm Dia.:36mm Shaft Dia.:3.175mm Inlude: -Motor,1pcs -Decal,1pcs
Tim
Reviewed in the United States on February 29, 2024
Low speed torque! It is going to be purchased again
Tayler Wambsgans
Reviewed in the United States on June 7, 2023
The media could not be loaded.
Jessica Meaney
Reviewed in the United States on July 12, 2022
Heres the gig -This isn't as smooth as a brushed hw1080 holmes setup,It's not as nice as the brushless 2 in 1's...But it's a seriously great motor for the price. Somehow it's pretty smooth and NOT sensored, with little cog. It sits on my TRX4 w/ Traxx kit. and it's super torquey, with almost zero heat build-up. It's good at crawling and great at trailing.
Happy
Reviewed in the United States on July 18, 2020
I have two of the three offered the 1750kv and the 2400kv they both perform better than expected. If you're building or upgrading your crawler to brushless these are the motors you want.
Timothy Castillo
Reviewed in the United States on June 13, 2020
Great motor dont expect speed but lots of torque parts WILL break before this motor gives. I put in a gen8 and tested in against the gen8 axe not as fast but has more torque literally and is priced very well.
Rc-Uly
Reviewed in the United States on July 30, 2018
Good slow crawl control, lots of torque and minimal cog. Must run with mamba X or will cog
Jonah Severson
Reviewed in the United States on April 17, 2018
this little motor really impressed me.i have it in a 2.2 wraith with stock equivalent gearing its got loads of low end torque considering its a sensor-less. very little cogging and some nice speed. the motors appear to be hand assembled, the rotors appear to be neodymium magnets and yes there are actually 6 poles and 9 slots. and its equipt with NSK bearings right out of the box. in all a solid brush-less motor with plenty of torque for your crawler
Peta Parkour
Reviewed in the United States on August 17, 2017
A crawler motor that's sensorless. I rolled the dice on this one. And honestly i was kinda surprised. Impressed even... Now, this motor was in my 1.9 wraith (crawler not bouncer) controlled with a SV3 (tuned on castle link, throttle curves turned down.) Powered by 2s. I hit the trail expecting "cog city" but it really didn't. It will cog if you try to make it or expect to roll SUPER slow, but it handles slow very well, it just needs a tad more throttle to get started. It felt different at first but about 20 minutes in. It was fine, it felt like a solid motor, I had no overheating issues, it didnt mind water either (i knew it wouldn't care)On a 2s it produced estimated wheel speeds of a 27-35t on 3s with torque of 45-55t on 3s. It's well worth a try if you want to check out brushless power without investing in a roc412. Its even better If you have an old Sidewinder 3 laying around, or in your truck already.
Recommended Products
$22.95
$ 10 .99 $10.99