Your cart is empty.
Your cart is empty.Product Description
Waterproof 12kg Servo 180 Dgree Metal Gear High Speed Digital Servo Motor for Helicopter Tail Robot Car Drone Boat
Working voltage: DC4.8~7.4 V
Speed (4.8V): 0.13 sec/60°
Speed (6.0V): 0.11 sec/60°
Torque (4.8V): 9.2 kg.cm
Torque (7.4V): 12.3 kg.cm
Size: 41.1X20.3X29.2mm
Weight: 44.5 g
Bearing: 2BB
Connection cable: JR 265 mm
Output gear: 25T (Futaba general)
Special Notice:
The RC Use-Angle 180 marked in selections to be shipped by Angle-180 servo, Cuz the below signal match with Angle-180 servo support PWM signal width 500-2500us.
Transmitter only can generate 1000-2000us, it is half signal of the servo, thus the feedback angle will be half at 90.
The Angle 180 which request pwm signal width 500-2500us, if you use a transmitter to control them, the angle will be 90.
Customer
Reviewed in the United States on September 8, 2024
Performs adequately for slower speed vehicles and fits well in any chassis ive put it in so far
Arron C.
Reviewed in the United States on September 14, 2024
For being budget servos these are great have ad no issues and all my planes still fly.
Shifter
Reviewed in the United States on September 13, 2024
It would work some of the time while others it would make a clicking noise and slowly rotate. you can turn by hand then it would start working again poor, poor, poor. I was going to return the servo but amazon forces me to drive 30mins to a ups store in a different town to send it back not worth the time spent. The servo does seem built solidly though if they could work out that one glitch it would be 5 stars but until then skip this servo.
strongman
Reviewed in the United States on December 30, 2024
I used them on my RC helicopter.
George Johnson
Reviewed in the United States on November 26, 2024
Works like it should good price!!
Alex S
Reviewed in the United States on May 7, 2023
I decided to give this servo a shot to see if it was a viable alternative to the JX 4409.It is a Tiankong servo (they also produce an all metal case low profile servo). They recently quietly modified that servo and slightly reduced the price (not as good as it was previously). I suspect, based on gauge of wire on this servo, that they commonized the design and only swapped the case.I hooked mine up to a Radiolink setup running off a 6V receiver pack. On power up and connection it immediately began making a clicking noise and slowly rotating. I have seen this behavior on other low end servos when the voltage gets too low I tried a different servo and had no issues so these servos are likely very sensitive to voltage (something that could be an issue for some).After that, steering behavior was erratic - sometimes it would move, sometimes not. Speed was average (about the same/slightly faster than a 4409).I ended up returning it - just cannot trust it. I think Tiankong sold/produced OK servos up until 2022 but have cost reduced them a bit too much.
seanciad
Reviewed in the United States on October 2, 2023
Not working properly and making a clicking noise. Maybe just a bad unit.
Alvaro
Reviewed in the United States on February 12, 2022
So works great for a replacement for Ecx Barrage steering servo, the original started slipping and was very weak. This one is way more responsive and stronger, and has metal gears , and the size is perfect for the Barrage since its limited space, replaced it with no modification i only needed an extender fir the connection leads which i had a few and are usually available at your hobby rc store...I would of loved a metal steering horn as well. I'd love to check out their other products as well.
Recommended Products
$43.99
$ 22 .99 $22.99