Your cart is empty.
Your cart is empty.These thin boards are machined S4S and are planed to 1/4" thickness, eliminating wear and tear on your planer. You won't have to worry about chip-out which is difficult to prevent when planing thin stock. Thin boards are ideal for edging, veneering, inlay, marquetry, sides for decorative boxes, bending stock, bent laminations and whatever else your imagination can dream up! Red oak is medium hard with a heavy weight but responds readily to sharp tools. It has good staining qualities and is often used for steam bending.
JBlairNY
Reviewed in the United States on April 22, 2025
Good quality, consistent milling, arrived well packaged.
Alexander
Reviewed in the United States on February 20, 2023
I used these to make dividers for tea bags in one of our kitchen drawers. They were just the right width, so I didn't have to do much - cut a bunch of slots, seal it and hook everything together. Some of the pieces arrived with a strange orange residue along the short edge, but it was too long for me anyway, so I cut it off. Be aware if you plan to use the whole length. There also was a little bow on some of the pieces.The price is my main complaint. I ordered less than a board foot and it was over $70.
Chuck Nyre
Reviewed in the United States on December 23, 2022
Almost 8 inches of one of the boards had worm tracks making it unusable. Quality control would have caught the defect
Recommended Products
$56.95
$ 27 .99 $27.99