Your cart is empty.
Your cart is empty.This complete 2pc drive shaft fits 2009 - 2014 Ford F150 4wd auto trans with the 157" wheel base SUPER CREW CAB.The original Ford drive shaft has a center bearing that can not be serviced.The custom drive shaft we offer comes with a serviceable center bearing, greasable u-joints and is fully balanced..Please verify length and pin # before ordering.(SEE BELOW). Front section = approx 27 1/8" band to band (weld to weld) rear section = approx 33 1/8" band to band (weld to weld) This shaft fits 2009 - 2014 F150 with ONLY these SKU# 's which is located on a sticker attached to the drive shaft tubing.(shaft can stay in truck to do this) AL34-4K145-KA, AL34-4K145-KB, AL3Z-4R602-KA, AL3Z4R602KB, 9L34-4K145-LF, CL34-4K145-HA, BL3Z-4R602-D, DL3Z-4R602-AL, DL34-4K145-HC, DL34-4K145-SA, DL34-4K145-SB, DL34-4K145-SC. Our shaft comes complete with serviceable and greaseable u-joints and is a fully balanced witch eliminates the need for round dampener on the transfer case yoke. This Drive Shaft comes with a 90 day Warranty. Warranty valid under normal use only (snowplowing, mud pulls, suspension alteration ect.) will void warranty.
Allister
Reviewed in the United States on February 26, 2021
Perfect fit, and great construction!!!
Van
Reviewed in the United States on September 26, 2020
Had the u joint on my driveshaft go bad and being non serviceable, it left me with little options. This replacement fits and works great and now I can carry spare u joints and have the comfort of not being stuck having to replace the entire shaft again.
Jennifer Vander Broek
Reviewed in the United States on October 31, 2020
Perfect fit, and a far better replacement than ford or other aftermarket shafts. Well built and I installed it on my super crew 6.5 bed in 30 minutes. 5 stars people.
vinny monteforte
Reviewed in the United States on September 12, 2019
My 2010 F-150 vibrated at 70 mph and of course my driveshaft was none serviceable 👎, TADD’s driveshaft arrived a few days later and it looked great! Nicely painted! Fully greased! Fully serviceable! Weighed about the same as my OEM shaft and it fit perfectly! And most importantly of all! no more vibrating!!
2k3Mach1
Reviewed in the United States on December 13, 2019
Update. I bought this 12/2019 and just had the carrier bearing fail on me.. No one around had a bearing that the part nu.ber is in stock. It will take 3 days to ship an equivalent part from Buffalo NY to get to me in Indiana. That takes off 1 star off my review. Part number for center bearing is n217334 and the universal joints are moog #331. Make sure you can find the center bearing in your area as it may fail on you.OriginalI had my carrier bearing fail on my stock driveshaft and needed to replace it. The stock driveshaft is non-servicable and basically throwaway if anything happens (bad u-joint, carrier bearing, etc). I can't believe Ford would put a $700 driveshaft in that could be taken out by a $40 carrier bearing. I then turned to find a "servicable" drive shaft which led me here. I ordered the driveshaft and within a few hours they emailed me to verify my stock driveshaft part number to make sure I was receiving the correct driveshaft. I had the correct part number and they shipped it. I received it second day in Indiana. I will say the quality of this shaft seems just fine and happy so far. I will verify tomorrow no vibration at speed, etc. I also will be touching base with TADD to find out what replacement parts to install in if these ever fail. I would definitely buy this driveshaft again if it was ever needed (etc replace truck in future, etc). Item was packed well in the box and installed in approximately 30 minutes with a 12 point 12mm socket for driveshaft and a 13mm socket for carrier bolts. I'll try to update review omce I get some miles on it
Recommended Products
