Your cart is empty.
Your cart is empty. Brand New - Unused Parts
Manufacturer Part Number 345702-4 Cross Reference (Fit/Form/Function) Replacement for Makita XTP01 and XTP02 Pin Nailers
Thickness 0.050" Overall Length 4.4" Width 0.4" Head
0.235" Body Location 02-12
Quality, Fit, and Workmanship are Fully Guaranteed.
Angela M. Scott
Reviewed in the United States on March 20, 2025
The driver i received was not the one pictured. It was a lighter colored, poor quality knock off, did not fit precisely and may have damaged my XTP02.
Rob Yates
Reviewed in the United States on August 12, 2024
All the reviews are correct. This driver looks same but isn’t. Jammed in my Makita XTP02 nailer then once I tried greasing & used again it immediately bent during first use. Beware!
Lily
Reviewed in Canada on June 1, 2024
Broken immediately after one test.The parts to be fitted here should be made using heat-treated iron. However, this product is made of a material that is too weak.Please give me a refund.
Owen Nicholson
Reviewed in the United States on March 27, 2024
Driver is too thick, once you tighten the head it won't fire. Tip broke of as soon as I fired the first shot.
Anthony
Reviewed in the United States on December 30, 2024
This piece is too thick and will not slide freely once installed. Save yourself a lot of time and buy the OEM part.
Brent Voiland
Reviewed in the United States on November 2, 2024
Terrible durability, the tup snapped off and it didn't last for a single rack of micro nails.Waste of time installing this inferior product
April A
Reviewed in the United States on November 13, 2024
Don't waste your time or money! You'd have better luck with something made from Tinfoil. For real!!
John K.
Reviewed in the United States on September 4, 2023
My driver broke in my nailer. I figured I would check to see if Amazon had a replacement. After getting this one, I was excited. It looked just right. After installing it, the gun sounded weird and would not fire. I opened it back up to find the driver bent in the slide. After comparing my old broken one and the new one I could see the subtle difference. The grooves were not cut deep enough and the driver sits proud of the slide. There's no way for this to work without me machining it out myself. Very disappointing.
pilot27j
Reviewed in the United States on December 12, 2023
I replaced the bad driver with the new one and on the first shot it broke.
Recommended Products
