Your cart is empty.
Your cart is empty.Product Description
CODACE Hidden RFID/NFC Locks for Cabinet Drawer
- 1)3 Modes: single card, dual card (up to 13 cards can be configured), NFC function.
- 2)Sensing area up tp 50mm, installed vertically or horizontally.
- 3)4 AAA 1.5V alkaline batteries or USB cable. (Normal can be used for 18 months.)
- 3)The sound alarm will alert when the voltage is low, the door will open automatically.
NFC Key Card Installation Guide — Android
- Note: For Android, copy rfid key to your phone's wallet via NFC fucntion.
NFC Key Card Installation Guide — IOS
- Note: For iOS, you need to hold an existing transit card or bank card, the card needs to be configured successfully, and add this card to IPhone Wallet.
Pre-Installation Preparation(IOS)
1. need an existing transportation card or bank card X1
2. an Iphone with wallet function X 1
3. electronic lock with AAA battery X 1
Add an existing transportation card or bank card
1. Install the battery, then use the included screwdriver to insert it into the hole of the reset button (it can be reset when you hear the sound of Di).
2. Hold the traffic card or bank card near the induction area of the lock until you hear a short sound (successful configuration).
3. Open your IPhone wallet and add this existing card scan to your phone
Input NFC Signal
1. Re-open the wallet and click Use Card.
2. After the electronic lock is unlocked, enter the mobile phone card information and confirm the input with two beeps.
Syed Aleem Ahmed
Reviewed in India on March 8, 2025
Good one
Paolo
Reviewed in Italy on January 7, 2025
Ok
STEVEN SOTO
Reviewed in the United States on July 28, 2024
Muy buena opción
W.S.V
Reviewed in the United States on April 23, 2024
I needed something to lock my liquor cabinets and I bought two of these locks. To install them was a bit tricky but not over the top tricky. My main concern with these locks are that they are battery operated and fearing the batteries dying while the door is locked - like I've seen happen in a few posts here. To address that issue I used the two sided STRONG adhesive tape. The purpose of this was just in case the battery died I could literally use enough force to tear the tape and open the door without completely destroying the inside of my cabinets. Maybe even use a hair dryer to heat the wood first - I dunno.The AUX USB power wire they have on this thing is a joke, I honestly took a look at it and laughed - it's useless. If the battery dies how the hell are you going to get AUX power to the box with the cable INSIDE. It's cray - cray.So how did I install the boxes and door pins?? I installed two sided tape on the power box and then plugged the pin inside the box just as if it were locked. Then without sticking the power box to the top or cabinet wall moved the box back into the cabinet until the door pin was even (flush) with the edge of the outer wall or top of the cabinet then I made sure it was straight then stuck it to the surface. NOTE: If your door is countersunk you will need to measure the thickness of the door and set the box BACK deeper to accommodate that additional measurement THEN stick it on the surface. See if you don't do that on a countersunk door it will stick out. Once the box was set in place, I then stuck an additional piece of two sided tape on the back of the door pin, made sure it was straight and even and just shut the door. Once the door closed all the way it stuck easily right where it needed to be. It sounds more complicated than it was.If anyone just pulls the door open the tape is so strong it would damage the wood but not destroy it. If I screwed in the TINY screws it would come out easier if it was yanked on AND it would do hole and surface damage to the inside of the cabinet - hence both would be detected letting you know it was broken into by someone. These are FAR from high security anything so no GUN lockers for these people.The cards (3) per unit were already coded to each box and they worked great!So far so good though :-)
Moe DeLawn
Reviewed in the United States on August 3, 2023
I cannot use this as you can see from the photo the 2 pieces are not flush so I cannot mount it on a cabinet door. Next, the instructions are essentially useless, poorly translated, leaving you to find other resources to install. Finally, it says it is not compatible with iOS, yet the information before you buy said it is compatible. I am returning it and looking for a better product.
pedro almeida
Reviewed in Spain on June 30, 2023
Bom produto e funcional. Só não leva 5 estrelas porque não é muito fácil de montar. Mas funciona muito bem e tem bom preço em relação aos produtos similares disponíveis no mercado.
Larry Gonzalez
Reviewed in the United States on January 13, 2023
The media could not be loaded.
xkss
Reviewed in the United States on August 1, 2022
I installed it in a drawer to be used as a gun safe. It was not easy to install, however, that's not a fault of this unit, but due to the way the drawer was constructed. I'm guessing it would be difficult to install in many situations, so unless you are somewhat handy, you might find installation a challenge. Once installed it seems solid, makes a reassuring clunk when locking or unlocking. The cards work through the wooden drawer front for unlocking no problem. You can use USB power or batteries, but not both connected at the same time. Wish they would have designed it so you could leave external power connected and have the batteries for backup during a power failure. The actual latching components are metal, just as pictured, but this lock is going to prevent only casual openings of the drawer, not a serious thief.
Jason
Reviewed in the United States on July 24, 2022
Really what I wanted was a gun safe that could fit a suppressed pistol but there's not many options out there. I put this on my well built night stand drawer and keep the rfid card attached to my cell phone. Much easier than using a pass code to open my safe and more reliable than finger print.Was a real hassle to figure out exactly where to place things for my install but eventually I got it done.
Chris
Reviewed in the United States on October 10, 2022
I was skeptical that this would function like I needed it to.It took about an hour to install on an Ikea dresser. The card programing was simple and the product has performed well.
John Wolstencroft
Reviewed in the United Kingdom on March 6, 2021
This is an excellent sturdy lock but you do need to be able to measure accurately to get it to work / fit snugly. If you can put up shelves etc you'll be fine but if you're not confident with a screwdriver and tape measure you may struggle and need help. It is an excellent bit of kit though.
David johnson
Reviewed in the United States on February 17, 2021
Farely easy to install for what it is. It definitely serves it's purpose. I installed this on a drawer ony nightstand and it definitely keeps the kids out. The instructions say the lock will unlock when batteries go dead, but I've been using it for almost six month now and they haven't went dead yet with using it almost every other day. This purchase was we'll worth the money. Too bad all this crap is made in china!!!
Kristin T
Reviewed in Canada on August 9, 2020
Exactly as described. Not the easiest to install if it’s a cupboard, cuz you can’t be on the inside to get proper placement, so some measuring required. Pro tip: make sure batteries are secured.
Recommended Products