Your cart is empty.
Your cart is empty.Andrea
Reviewed in the United States on June 1, 2025
The box was torn open when delivered and the mounting screws weren’t even in the box also the item was slightly damaged
Helena Garcia
Reviewed in the United States on January 4, 2025
poor quality. Broke before I could hang it up.
Jesse
Reviewed in Canada on December 17, 2023
Works as it should.
Aaron
Reviewed in the United States on September 1, 2022
These were extremely easy to install and seem very durable. Highly recommend.
Nathan
Reviewed in the United States on May 16, 2022
These are super cheap. I would definitely not recommend these at all. Laminated press board popped off before I even had it installed. Definitely going to return
Destani Olivarri
Reviewed in the United States on February 15, 2022
Bought this for my boyfriend, and he loved it and said it was easy to hang up. It comes with nails, holds his fishing poles perfect.
Richard Mendez
Reviewed in the United States on December 20, 2022
These are very appealing to the eye, but very cheap.
Gordon Turner
Reviewed in Canada on October 13, 2022
Easy to install. Looks good. Displays the rods and reels great. But over priced!
Alex
Reviewed in the United States on January 3, 2022
The idea behind these are great, but the execution of the idea is pitiful…they couldn’t have used a less expensive material to construct these if they tried, might as well be wet card board. The screws/anchors provided just spin inside the dry wall as you tighten it down, I bought replacement anchors and the screws were too short so I drilled the holes deeper, tightened down the new anchors and they still weren’t tight against the wall. Save your money and buy something else
J Dees
Reviewed in the United States on October 22, 2021
The screws are long enough to get through drywall and just barely bite the tip of the screws into a stud - inadequate. No problem, I though, I’ll just use common drywall/wood screws, nope! The heads on their screws are smaller than their heads on any of the numerous types of screws I have, so standard screws will not fit inside the recessed holes. Either I have to bore out the holes in the rack or make a trip to the hardware store for the right screws that should have come with the product in the first place. A job that should’ve taken five minutes is now 45min-2 hours and i need to purchase additional parts. Thanks guys.
Recommended Products