Your cart is empty.
Your cart is empty.Rob
Reviewed in Canada on March 6, 2025
Work great. I stacked both seals to effect a good seal around the entire light. Lost a star due to no instructions. But it does the job
Galen
Reviewed in the United States on March 27, 2025
Right thing worked great and send extra for later on have a extra fit perfect.
mike v
Reviewed in the United States on February 28, 2025
I had this constant leak, water kept dripping from the seatbelt and the driver back side, replaced the seal on the break light and no more water
Bob Mann
Reviewed in the United States on January 13, 2025
It is a proper gasket for my third brake light.
Dieselmh
Reviewed in the United States on January 10, 2025
The only problem I had is that the foam that needed to be removed wasn't cut through far enough in some spots, and wanted to tear the gasket portion I needed to stay intact. Once I realized this, some scissors made it an easy fix. It fixed the leak on my 07 2500. No more musty smell! Installation was easy, and they're much cheaper than the ones at the parts store.
I & J
Reviewed in Canada on April 12, 2025
Easy to install. Fits correctly. Seems to be keeping the water out. We had a pretty serious rainstorm the day after I installed the seal. Time will tell...Thanks
Daniel Murray
Reviewed in the United States on September 11, 2024
I replaced my 3rd brake light bulb and had a leak in rain storm right after. Brought this new seal kit and no more leak. WooHoo
Paul S.
Reviewed in the United States on August 4, 2024
I purchased these more than a year ago. Installed easy and work as advertised. No more leaks or stains on 2006 Ram rear seat.
Caleb Logsdon
Reviewed in the United States on June 8, 2024
Foam seems to be of good quality, cuts are nice and clean. It is just about 1 inch too short (lengthwise) to fit the Ram 3500 mega cab 3rd break light.
Ryan Kaldhusdal
Reviewed in the United States on October 31, 2024
I installed this last week. Had our first rain since I found the leak. All is good works as expected.It also comes with 2 seals just in case.
Joselyn Rimell
Reviewed in Canada on September 12, 2023
So a couple of thoughts to share. First, shame on Dodge for the shitty design. Should be recalled.Anyway, I used a dull putty knife to remove the old seal, so I wouldnt damage where the seal sits. Then used glue remover to remove, well, the glue (Würth adhesive remover). Then rubbing alcohol to prep for the new seal. When placing the new seal on, be sure to place it at the top of the seat. I placed the first one too low and had to use the second seal to correct the mistake. Good thing it comes with two! Cleaned the dirt off the truck and reinstalled the seal. Because the light has bent with the heat of the sun, or the pressure of the end screws the seal isn't super tight. Certainly tighter than the old one, and I pretty sure it will keep out water, but ultimately I think the solution is to replace the light every 8-10 years. 😞 Also, hard to test without removing the headliner.
Tony Wiebe
Reviewed in Canada on July 19, 2023
Sealed up nicely on my 08 ram. Poured water on the roof and onto the third brake light. No water running from the upper headliner anymore. Time will tell the true test but for now it gets a 5star rating.
Wayne
Reviewed in Canada on March 7, 2021
This item worked without any trouble to install
Recommended Products
