leo A
Reviewed in the United States on April 15, 2025
after removing the old round 7/8 seal it exposed seven screws holding the other seal in place along with the 3 m after removing the screws it made the total installation easier. re installing the screws helps to secure the seal to the side wall better.
Customer
Reviewed in the United States on April 15, 2025
Worked and fit as described. Would purchase again
dnd3300
Reviewed in the United States on April 1, 2025
Worked as advertised
Mike S.
Reviewed in the United States on July 4, 2024
Appear to match OEM seals. Good fit and adhesion, seem to be good quality, will see how long they last.
chris dossey
Reviewed in the United States on June 12, 2024
Good rubber! Seal not fit camper. Give up on task. Take nap.
Michael Kelso
Reviewed in the United States on May 13, 2024
This seal was an exact fit of the old ones. Slide on very easy.
PC Acton
Reviewed in the United States on March 18, 2024
Worked great and was easy to install. Only bad thing is the adhesive was poor quality so we had to add some adhesive to the product.
Frenchfry
Reviewed in the United States on April 15, 2024
The time had come to replace the seals on my rv slides. I looked at several different brands and types and ultimately decided on this one. The price range of these items is off the chart which made me go to this one. I figured I could send back if the quality was not as I expected/needed. The quality ended up being very good and glad I purchased this one.Even with my great rating, there are a couple of downsides. The boxes are not marked with the length. I thought I ordered two different length and pulled them out an measured. They were all the same. That actually is what I ordered. Still, the boxes should be marked. The other downside for me was I had an issue upon installation that causes some of the 3M adhesive to not hold. It was always on an end of the piece upon installation. I do not think it was a manufacturer issue, I think it was how I did the install. Luckily, I had some adhesive to use. Before you install, I would make sure you had some adhesive available as a just in case.