Your cart is empty.
Your cart is empty. Self Regulating Heating Cable 220V 230V 240V To Prevent Pipeline Icing And Tracing System Defrost Snow Melting
Cable type: self-regulating heating cable
Working voltage: 200~240V AC
Rated power: 20W/m (at 10C degrees)
Max maintain temperature: 65C degrees
Max enduring temperature: 135C degrees
Width * Thickness: 8.1mm * 3mm
Min bend radius: 15mm
Conductor: tinned copper wire
Jacket: PE
Max circuit length: 30m
Structure:
Copper conductor
Conductive heating element
Inside extra insulation
PE outer sheath
Self-regulating Working Principle:
This cable is suitable for household drinking water pipe, drain pipe freeze protection in winter and other heating applications.
The cable can self regulate the output power according to the temperature, it won't overheat, so the temperature controller is not necessary.
The cable is with PE jacket, and inner has the PE composite insulation layer, better water-proof and good quality.
Installation Steps:
1) Seal the end of the cable with heat shrinkable tube or other electrical insulating tape. DO NOT connect the two conductors together!
2) Connect the other end with cold wire or plug (for connecting to the power supply).
3) Wrap the heating cable on water pipes or fastening straight on pipes, both are ok. Put the whole cable on the pipes and fasten it every 30~60cm with thermal tape or aluminum tape(sold in my store).
4) Suggest to wrap a layer of rubber insulation on the pipe, enhance efficiency of the heating cable and save energy, also can protect the heating cables.
5) Connect or plug into 220~240V. The heat trace system is finished.
Tips: max circuit length ~ 30 meters.
$164.95
$ 81 .99 $81.99