Your cart is empty.
Your cart is empty.Adrian D. Nedelcu
Reviewed in the United States on April 16, 2025
There's a trick to it. You're going to need two sets of complete foldable allen wrenches to perform the operation, some oil lubricant and a cloth to clean up the screw. Remove the base of the large latch first by putting in two allen wrenches, using one side for leverage as you work out the other. Clean that screw and set aside. On your old broken drive shaft bolt, remove the screw in the middle of the large bolt shaft then pop the small plug out of socket. Do the same to the other side. Install your new bolt screw into the latch first, then bolt the latch back on, then install the small nub at the top and finally put the small bolt in. Adjust the two nuts to get a firm hold. Easy. If you force it without doing this method, it will break.
Emmanuel Mondesir
Reviewed in the United States on September 28, 2024
Seconds within trying to fit it into my segway it snaps. I didn't even get to snap it in. Now the snapped part is stuck in my scooter and I don't even know how to take it out.
Recommended Products
