Your cart is empty.
Your cart is empty.Product Description
The Shark 01-2312 12" Replacement pull blade for 10-2312 12" 14 TPI carpentry saw is designed to cut all types of wood and does a wonderful job in PVC and ABS plastic pipe.
From the Manufacturer
Replacement blade for 10-2312 12" General Carpentry Saw. A great all around saw for every toolbox. Cuts all types of wood and does a wonderful job in PVC and ABS plastic pipe. 14 teeth-per-inch allow smooth, fast cuts. If you are only going to own one hand saw this is the one you need for all of your jobs. Not for cutting metal.
RWW
Reviewed in the United States on January 5, 2025
Damage a tooth on a pull saw and your pretty much done - so the slip on blade guard is important to keep.
Suzanne Kagen
Reviewed in the United States on January 20, 2025
It's a good fit to my original Shark handle, but it's not quite as scary sharp as the original. Man, that original blade from 25 years ago would cut through hardwood with hardly any pressure. This one is OK but not the same.
Bert
Reviewed in the United States on July 21, 2024
nice blade, easy change, wish it was cheaper, but well made, finished. just be easy on it. not for cutting trees.
David J.
Reviewed in the United States on October 14, 2024
these pull saws work extremely well for times when you don't want to drag out your skill saw or powered miter saw and only have a few cuts to make
Mr Meticulous
Reviewed in the United States on August 13, 2023
Excellent for trimming tree branches! Excellent for general use and has a very small accurate kurf.
Paul Dorman
Reviewed in the United States on November 26, 2023
I've been using these saw blades for a few years now. When it's new and sharp, it cuts very quickly. When it's no longer cutting as well, I can get a new one for not much money.
Lee Fottler
Reviewed in the United States on April 30, 2023
In all fairness I haven't used this blade yet as it is quite fine tooth and haven't had the need yet, BUT I have purchased and used the coarser version with the Japanese pull tooth and they are the same blade just different tooth. If you are ordering this for your older Marples handle, they do fit, but you will have to get your Dremel out. Comparing to my old Marples blade these are a bit longer where it inserts to the handle on the upper finger. Also, the hole for the push button is a whiskey small. Now some folks report that theirs fit no problem at all so I will assume there is some variation in the handles.So if you don't mind doing a bit of "fitting" theses are a great replacement for the old handles, if you want plug and play, buy a new saw.
Dr. Z in the NW
Reviewed in the United States on August 25, 2022
If you have not added a Japanese pull saw to your tool box, do it now! They cut accurately and quickly through most wood leaving a clean cut. After many years of use, ours needed a new blade and this is as good as the original.
Recommended Products
