Your cart is empty.
Your cart is empty.Product Description
Chris Hewitt
Reviewed in Canada on November 23, 2024
Worked flawlessly.
DG
Reviewed in the United States on February 1, 2023
HORRIBLE - does not work at all - even if it did as another reviewer said the screw terminals are way to small to attach wires to - I ended up soldering wires to the bottom and covering with hot glue - still no joy - it's literally such a bad product I'll keep it so there is no chance you might buy it. I would never trust this to turn on the load it's rated for.
HardRockFan
Reviewed in Canada on April 8, 2022
Bought to replace a mechanical relay which was causing interference when it was opening. The device only uses max 0.4A @ 120v, controlled by a 5v microcontroller, so bought this, installed it and it was not turning on.So I bench tested it and it didn't work at all.Things to note:The terminals where you put the wires are very small, it's hard to fit the gauge of wire you would use on a 120 volt appliance, I had to bend the metals tab inside the holes to get the wires to fit.The screws used to tighten down to clamp the wires are extremely small, you need a tiny screwdriver to fit in there, I used a watch screwdriver, problem is that limits how much torque you can put on the screw.The PCB is exposed and there's no good way to mount this. I wrapped it all in electrical tape to make sure nothing shorts out.In the end I bought a "SSR-25DA" for a few more dollars, which is what I should have done in the first place, it's better in every way to this SSR, big wire terninals, normal sized screws, non exposed electronics, a place to mount (that is metal so it will dissipate heat too), more current capacity and wider voltage range.
Michel Morin
Reviewed in the United States on May 2, 2021
work perfectly and the right size for my prefect thanks
Barry Nash
Reviewed in Canada on January 8, 2021
I found out after my purchase that the switched load has to be AC ( alternating current). I need to find one that is for DC.
Alarmguy
Reviewed in Canada on October 14, 2020
It works. I haven't noticed any soldering defects, which is often common in relay boards.
Recommended Products