Your cart is empty.
Your cart is empty.
Technical parameters:
Input voltage: 6V-36V (2-8S Li Po)
Output voltage: 5.2V, 6.0V, 7.4V, 8.4V four options
Output current: continuous 8A, instantaneous 16A
Size: 51mm x 36mm x 8mm
Weight: 32g
Pauls
Reviewed in the United States on May 8, 2025
Good quality I just wish they would come with some connected to it cause you got a solder it or or crimp it or do something and it just should come automatically would either a Dean’s Anderson or an XT 60 or an EC three but they don’t, and that’s the only thing I find that’s kind of frustrating. Other than that they’re good
Dave K
Reviewed in the United States on April 28, 2025
Handy for mixing 2 cell LION batteries with 6 volt servos!
hollebeuger
Reviewed in the United States on September 20, 2024
Good fit works well easy to change voltage.
James buck
Reviewed in the United States on May 8, 2024
It eorks its definitely wired kinda weird i rewired it but its huge and it works but save some money and get a castle bec
Carey Butler
Reviewed in the United States on January 26, 2024
Installed in my Trex 600 heli, straight hook up to 6s 5000mah and performing well. lets hope it stays that way. about 14 flights so far, dose not get hot, barely warm.
Richard L. Schmier
Reviewed in the United States on January 11, 2024
Hooked everything up. Double checked it was all correct. Powered by a 3s lipo, set bec to 8.4v, receiver rated to 9.6v input. Made sure positive wire on esc throttle plug was removed. Powered on the bec and everything worked great for 5 seconds and then my brand new $60+ receiver stopped working and the car went into fail safe mode. Needless to say, I'm pretty upset.Also, this is the biggest bec I've ever seen. It doesn't even come close to fitting in the receiver box and it doesn't look to be water proof at all.
dditthardt
Reviewed in the United States on August 17, 2023
I stuck this in a very old onroad touring car to run a more powerful servo than the BEC could provide. Hooked it up to old servo and tested, voltage was what it should be at each jump and it handled the stall amperage(6A) of the new servo without getting hot at all. I ran the car for a half hour at 6v and it was still just warm. I will be moving to 8.4v soon and I will update this review when I have more to share.Update: 8.4v works, it even boosts from 7.2v nimh. And it doesn't even get hot!
Customer
Reviewed in the United States on November 12, 2023
Direct wired to battery running 8.4v and so far no issues
Recommended Products
$57.99
$ 25 .99 $25.99