Your cart is empty.
Your cart is empty.real tremblay
Reviewed in Canada on March 7, 2025
Convien parfaitemant
zipitypete
Reviewed in the United States on February 18, 2025
I replaced the tires and rims with wider ones. These do a better job of protecting from the mud. They fit perfectly, and I was able to use the original screw holes. I would recommend them.
Pawpaw
Reviewed in the United States on January 29, 2025
Purchased these for 2024 Can-Am Defender HD 10 LoneStar. They fit the bed just fine. But after that it is going to take considerable trimming and fitting. The reason for this the factory rock sliders on the lone star. You have been warned.
joe ferguson
Reviewed in the United States on January 26, 2025
Fender shields are ok but the front could fit better .
Dawson
Reviewed in the United States on January 10, 2025
Installed on a 2020 Defender Limited. Great flares for the price, awesome coverage and stopped slinging mud up the sides. Added some rubber u channel edge trim in the front to keep from damaging the camo and seal the edges. Overall recommend to anyone looking.
Tyler
Reviewed in the United States on September 25, 2024
Fit pretty great and came with everything needed. Premarked holes on my 2024 Can-Am Defender XT HD9 lined up perfect. Time will tell on durability.
Ronald T. Holt
Reviewed in the United States on August 31, 2024
No issues.
JuLie Russ
Reviewed in the United States on November 18, 2024
Bought to stop mud from flying everywhere and these did the trick
Moparhorsepwr
Reviewed in Canada on January 28, 2024
Easy installation and looks good. And they look durable.
Çorey
Reviewed in Canada on April 3, 2024
good
Sam
Reviewed in the United States on April 17, 2024
I purchased these these because I didn’t want to spend $500 on the super atv or $250 on the CanAm set. These work perfect would definitely buy again!I trimmed the back set with a dremel so they don’t go down as far and so I wouldn’t have to drill into my skid plate.
Neil Kigutaq
Reviewed in Canada on November 3, 2023
The product is exactly what I wanted and fit the UTV, recommended drill holes were all correct.Fastening one of the pieces in the rear was a little more difficult as it was a tight spot, I did not have to disassemble any parts of the machine to install these parts.Spare washers to place more support for your preference is an option I would suggest prior to your installation.
Recommended Products