Your cart is empty.
Your cart is empty.Kylie
Reviewed in the United States on March 12, 2025
Looks great! Easy to install and cost effective upgrade to my Jeep!
Brenda Lawton
Reviewed in the United States on January 24, 2025
This was a birthday gift for our grandson in another state. He immediately put them on his Jeep Grand Cherokee and loves them!
Rocco
Reviewed in the United States on January 21, 2025
Fits perfect and looks great
Alejandro Guevara Pedroza
Reviewed in Mexico on January 16, 2025
Supongo que el producto está muy bienPero mala experiencia con los repartidores nunca llegóMal la logística de entregas
Kevin
Reviewed in Canada on June 14, 2024
So far holding up. Good quality
Jaz
Reviewed in the United States on March 4, 2024
Clips broke a little on the left side trying to put them back in, otherwise it’s a perfect fit and great cheaper replacement piece! Please note it’s an actual *replacement* not an overlay or anything. And to get it on, you have to pop (literally there are two body clips holding the front of it on) the bumper off and take out the fog light. Even with the driver side bottom one (there was a little piece that broke, remember?) it doesn’t rattle or anything.
jalen
Reviewed in the United States on December 3, 2024
I wanted to go with a more sleek route and found that with these, fog light covers/frames. They are not the easiest to install if you try the route of not removing the front bumper (yes it can be done). The quality of the plastic is definitely superior than the chrome covered OEM plastic covers. I’d say I got my moneys worth.
Phil S.
Reviewed in the United States on December 19, 2023
These look great on my 2019 Jeep Grand Cherokee. I did have to remove the bumper to install them but it is not that hard. Just a few clips underneath and in the wheel wells.
Arnulfo Cardenas
Reviewed in the United States on September 22, 2022
Mikaël Sayegh
Reviewed in Canada on May 1, 2022
Mathew Rudd
Reviewed in the United States on March 9, 2022
These are a great fit and look nice. You do not need to remove the bumper, simple remove the reusable plastic tabs at the bottom of the wheel well liner and pull that back from there you can access the 2 screws on either side of the housing. You then use a trim removal tool (can get a pack of them from harbor freight for $10) to remove the housing and replace the trim. I wish I would have made a video of it but is much faster and easier than removing the whole bumper.
Brendan
Reviewed in Canada on November 10, 2022
For a cheap plastic overlay these actually fit flush and look great. Good purchase for the jeep if you’re looking to black her out.
Recommended Products