Shopping Cart

Your cart is empty.

Your cart is empty.

SSR-100DD Solid State Relay DC to DC (Input 3-32V DC Output 5-60V DC) with Heat Sink, 100A

4.7 (5) Write Review
Free shipping on orders over $29.99

$17.87

$ 7 .99 $7.99

In Stock
  • Model: SSR-100DD, single phase Solid State Relay 100A DC to DC control, CE Compliant to EN60950-1
  • Input voltage 3-32V DC, Load voltage 5-60V DC, Max load current 100 Amp
  • Rugged epoxy encapsulation construction, high isolation over than 50MΩ(500VDC), high dielectric over than 2.5KV, output snubber circuit protection
  • No EMI/EFI & Low surge by Zero Cross Trigger method, specially suited to control sensitive, capacitive and Non-saturated inductive loads
  • SSR switches use semiconductor component acts as a switch for the relay, no moving parts inside, no mechanical wear, no action noise, no mechanical failure, and high reliability


DMWD Low cost single phase solid state relay SSR-100DD

Input voltage 3-32V DC

Load voltage 5-60V DC

Load current 100Amp


100A 3-32V DC to DC solid state relay (SSR) features high structural strength, good impact resistance, and strong shock resistance. The SSR offers a reliable switching the commercial and industrial loads, such as computer peripheral interface device, printing machine, molding machine, food machine, packaging machine, and so on.


  • Built in RC absorption
  • Photoelectric isolation
  • SCR output
  • LED indicator for operation status
  • Panel mount
  • Zero-crossing switch type
  • UL Approved, CE Compliant to EN60950-1


Note:

* When the load current is higher than 10A, a heat sink must be installed to the solid state relay, or the SSR relay should be mounted on a metal base plate with heat dissipation effect, and the thermal grease is applied between them.

* When the load current is 40A or more, a fan cooling radiator or water cooling radiator must be equipped.

* Heat sink is included.


Package Content:

1 x Solid State Relay

1 x All Aluminium Heat Sink


Size/Weight:

SSR(60x45x23mm/100g)

Heat Sink(78*50*50mm/80g)


Warranty:

Free new replacement in 5 years, Have faith in quality


T H
Reviewed in the United States on September 27, 2024
This unit is dead on arrival. Would allow a 5VDC or 12VDC load of 1-2amps to flow across the load terminal even without the control signal wiring connected at all!Buyer beware and test these immediately after receiving so you can return them within the exchange window!
NJK
Reviewed in the United States on December 23, 2024
It lets the full voltage through, even when the control voltage is disconnected.
Joshua Deaver
Reviewed in the United States on November 28, 2024
Purchased two of these and both had the same issue. Even when the relay is powered off, it allows 6v of the 12v load thru the relay, providing voltage to equipment it should be turning on or off.
Jerry Tusch
Reviewed in the United States on November 1, 2023
Very good assortment if fuse holders and fuses. I would have liked to see a few lower amperage fuses such as 1 Amp and 2 Amp, but overall a lifetime selection of experiments protection.
gmm
Reviewed in the United States on July 2, 2022
I didn't expect them to live up to their rating, but my SSR had a voltage drop of 1V at 10A, meaning they're using a 0.1 ohm (and more as it heats up) Rdson FET, which is pretty horrible.