Your cart is empty.
Your cart is empty.
Specifically designed with strong, yet soft, plastic material that won't damage coaxial, data, electrical, or other wire and cables. Additionally, by using a special PE UV material, no electrical shorts are created (as seen with staples or metal clips).
Added ridges 'lock' the clip in place, allowing it to automatically adjust to a wide variety of cable and wires sizes. Allows for near 360 degrees of grip, so that the cable will not slide back and forth for most sizes.
High Quality, Outdoor Rated, UV Protected PE Clip and Long-Life Yellow Zinc plated screw anchors are designed to be strong and easy to install. They are pre-installed into the clip, saving time and making installation much easier.
Twin mounting head allow for the use of either a 1/4" hex drive bit, or a standard #2 Phillips head drill bit. A standard #2 Phillips head screwdriver may also be used to install the clips.
Package of 100 Black Clips. Clips allow for an additional 16-30AWG wire to be installed alongside the primary wire, for use with grounding of antennas and satellites.
TK
Reviewed in the United States on April 30, 2025
These work fantastic. I would definitely buy them again.
frankdog
Reviewed in the United States on August 30, 2024
Pretty much all of the clips that directv used to route the dish's cable from the front of the garage down around the side and into the basement had cracked over the past dozen+ years leaving the cable hanging in several places. Replaced about a half dozen a couple years ago, and needed another bunch to replace the rest. These seem to be perfect for the task, and with 100 of them got some backups should any of them fail. They all get plenty of exposure to the sun and the intense wind we can often get, these seem like they will be holding that cable tight (no more cable banging against the outside wall when it gets windy.) (The directv ones didn't wrap all the way around the cable, just the front side of it, fwiw.)
C. A. Jones
Reviewed in the United States on July 8, 2024
Easy, one-handed installation with a powered nut-driver. Makes cable installation quick, easy and neat.
Musicmom
Reviewed in the United States on June 11, 2024
I ran a cable from my outdoor antenna to my TV. Cables tend to be curly from being held so tightly, so I used these clips to wrangle it into place along the edge of my porch. Now my porch looks great because the cable is mounted, and I don't have to worry about someone tripping over the cable. One minor thing - the item is small, so it's a little difficult to screw in the bolt up against a wall. A power drill won't fit unless the screw goes in crooked. That worked for me, but just be aware.
S. Lee Davis
Reviewed in Canada on May 12, 2024
Bought these to organize my coaxial and CAT5 cables through my home. They work great, easily tie down the cables and the included 1/4” drive screw is a bonus. Never had a single one break and now all the cables are neat and tidy. Much better, easier and cleaner looking than using the cable clips with nails.
Jaaa
Reviewed in the United States on November 18, 2024
Screw head have to be a bit bigger so they stay in correct bit.
Stewart F.
Reviewed in the United States on September 14, 2023
The cable clips are, quite simply, the highest quality and easiest clips I have every used. The material has the right level of thickness - not too much that they stand out but enough that they never tear, move, shift, or let the cable slide. The clamp material is just "sticky" enough that cables do not slide or move once the clamp is tightened. That makes it very easy to have a nice tight installation, as I can lightly tighten the screw, then pull on the cable to straighten it, do a final tighten on the screw, and everything stays in place.I have used these clamps on a variety of cable thicknesses - and I love the fact that the clamp adjust to different thicknesses very easily. In cheaper clamps, it becomes a pain when the cable thickness does not let the screw fit through the back hole. In these clamps, the back hole for the screw is actually a slot, and the clamp will open up a little for thicker cables without stopping the screw from going through. Cool feature - the clamp has ridges along the slot, which essentially locks in the clamp when the screw is tightened, preventing the slot from opening and thereby holding the cable tight.The screw is great. It has 1/2" of threads that bite in wood, plaster, sheetrock, etc. The 1/4" hex head prevents the screwdriver or power tool from slipping off. Anyone that has done cable management in tight quarters knows the need for a third hand sometimes to get the job done. These clamps pretty much bring it back to a two handed operation :)I have used both the single and dual clips. The dual clips worked great when I was running 2 network cables outside. These clips work especially well for all Cat6 Outdoor Cable.My only wish is that the screw was also black, as I find the metal-colored screws kind of stick out like a sore thumb when I have black cable and black cable clips.
Carrianne E.
Reviewed in Canada on August 3, 2023
I purchased these to instal outdoor lights around my patio door and along a lattice fence. They were perfect for this application.
Customer
Reviewed in Canada on June 6, 2023
Worked beautifully as advertised
Savvy V
Reviewed in the United States on September 29, 2022
These work fantastic! This summer my husband and I built fencing around the house as well as a chicken run. I didn't want to use staples that would easily come out if any type of pressure was put on the fencing wire and I wanted something durable that would keep critters out of the chicken run. These are easy to use and keep everything secure. I highly suggest these, and if you are looking for something to secure wire more effectively than staples, these are it.
Tug
Reviewed in the United States on November 6, 2022
This is exactly what I needed to hang some BNC power and video cable. The screws are set back so the points don't scrape against the cable when you slide the clip over. The length of the screws are just right for me, as I screwing into 1/2 plywood. I used a cordless driver and a 1/4 inch bit socket. Easy peasy! I'm happy.
Customer
Reviewed in Canada on February 11, 2021
I used these to fix an ethernet cable to floor joists and studs. Worked as expected, great product at a very reasonable price!
Flint
Reviewed in Canada on October 17, 2020
Easy to install and can be tightened to hold cable securely or leave looser for adjustments. Worked great for installation of my security cam system. Oh and fast shipping too!
Recommended Products
