Your cart is empty.
Your cart is empty. **Verify the part fits before purchasing**
Specs:
Description: Gasket Material Kit
Ethanol: Not compatible with greater than 10% ethanol fuel
Length: 6"
Width: 6"
Kit contains the following: One .060 inch CN-705 highly conforming cork filled material
Two .031 inch N-8029 fuel & oil resistant reinforced cellulose material
Two 020 inch N-8092 fuel & oil resistant reinforced cellulose material
Two metal reinforced high temp exhaust/head gasket material
Bill Babbitt
Reviewed in the United States on February 19, 2024
These sheets can make just about any gasket you might need for a small engine.
Customer
Reviewed in the United States on March 6, 2023
Ordered for different projects. The different materials and thickness comes in handy and very useful. Would recommend this product to others.
Prosper50
Reviewed in the United States on October 16, 2022
I normally don't leave negative reviews, but I felt compelled in this case since literally every piece of material in this pack miserably failed its advertised intent! I purchased this assortment because I had to replace some old gaskets for both exhaust applications as well as fuel/oil applications in a small gasoline engine. The exhaust material was horrible to cut and work with - it was basically a sheet of thin metal with some paper poorly adhered to the top and bottom. The gas/oil material was easier to work with and I had higher hopes. I installed all gaskets. I immediately had exhaust leaks from the 3 locations where I installed the gaskets made out of the exhaust gasket material. Likewise, everywhere I created gaskets for the fuel/oil application, it almost seemed like the gasket material wicked the fuel. The gaskets were immediately wet at the edges, and the outer areas of the metal components had fuel and oil on them as a result. HORRIBLE material - if I could give it ZERO stars I would. Literally nothing in this pack worked - I could have used cardboard pulled from the trash and had a better shot of it acting as a proper gasket. The only bit I didn't use was the cork gasket, as I had no use for that. I threw out the leftovers of all of this garbage.
Ourstuff
Reviewed in the United States on March 13, 2021
Works great
Diane Harrell
Reviewed in the United States on May 17, 2020
I used a small piece of this gasket material to make a gasket for the carberator on my Earthquake auger. WOrks like a champ again!
Recommended Products
