Your cart is empty.
Your cart is empty. "This dual shaft Nema 23 stepper motor with 1.8 deg. step angle (200 steps/revolution).
It with 8 wires, which you can give three connection options: Unipolar or Bipolar(Serial) or Bipolar(Parallel), you can choose any type as you wish.
A rear shaft can mount encoder, hand wheel or equals.
Electrical Specification:
* Manufacturer Part Number: 23HS33-4008D
* Motor Type: Unipolar/Bipolar
* Step Angle: 1.8 deg.
* Holding Torque(Bipolar): 2.83Nm(400oz.in)
* Holding Torque(Unipolar): 2.0Nm(283oz.in)
* Rated Current(Bipolar Serial): 2.83A
* Rated Current(Bipolar Parallel): 5.66A
* Rated Current(Unipolar): 4.0A
* Phase Resistance(Bipolar Serial): 1.6ohms
* Phase Resistance(Bipolar Parallel): 0.4ohms
* Phase Resistance(Unipolar): 0.8ohms
* Inductance(Bipolar Serial): 7.2mH+/-20%(1KHz)
* Inductance(Bipolar Parallel): 1.8mH+/-20%(1KHz)
* Inductance(Unipolar): 1.8mH+/-20%(1KHz)
Physical Specification:
* Frame Size: 57 x 57mm
* Body Length: 84mm
* Shaft Diameter: 6.35mm
* Front Shaft Length: 21mm
* D-cut Length: 15mm
* Rear Shaft Length: 15mm
* Number of Leads: 8
* Lead Length: 300mm
* Weight: 1.3kg
Connection:
BLK(A+), WHT(A-), BRN(C-), ORG(C+), RED(B), PUE(B-), BLU(D-), YEL(D+)
Warning:
Make sure the motor connect to a constant current or chopper drive controller before you test motor.
Connecting the motor directly to a power supply will destroy the motor. "
Verner Olsen
Reviewed in Germany on April 20, 2025
Not tested yet..
Mark P.
Reviewed in the United States on May 25, 2017
Worked great
MacGyver2.0
Reviewed in the United States on April 28, 2016
It tested OK, and can't wait to get it working for me. I like this motor, as it will be a good strong motor to use in my project. 8 wire steppers have a wide range of uses, and am looking to experiment with all of them! Thank You!
Recommended Products
