Your cart is empty.
Your cart is empty.Frank
Reviewed in the United States on September 16, 2024
I wish I knew about this years ago. This is the perfect socket to have for my Jeep. 8mm and 10mm pretty much covers everything I need for minor maintenance. I recently used this to remove the upper half of the air box to check the engine aire filter. This is so handly, I'm thinking of getting another one to just keep in the glove box.
K. Smith
Reviewed in the United States on July 20, 2024
Husband said works great.
Gene
Reviewed in the United States on June 8, 2024
Really like this but wish it was 6 sided
Adrian Duncan
Reviewed in the United States on March 17, 2024
But this a great tool and I love it.
Bear
Reviewed in Canada on February 14, 2024
Sunex socket are excellent quality, made in Taiwan
Customer
Reviewed in the United States on October 11, 2024
The socket is awesome for my junkyard bag and on my magnetic holder on top my toolbox. I just wish it was a six point living in the belt 12 points sockets can create major headaches.
C. Whitney
Reviewed in the United States on January 19, 2024
8 & 10 are just So Common, and having them Both available with just the "flip over" is such a brilliant idea!
Lee
Reviewed in Australia on October 8, 2023
This socket is very good for under tray bolt where there change from 10mm and 8mm just flip it round and your all good
jay
Reviewed in Canada on January 31, 2023
Works perfectly. Very convenient
Victor Villanueva
Reviewed in the United States on December 27, 2022
I love to have two size sockets i wish there is more
Customer
Reviewed in Canada on November 26, 2019
Absolutely worth the money, swapping between the 8mm and 10mm on the fly is very useful. I do not waste time walking to my tool box or searching for the other socket. It is not a fix all solution though, due to the length of the socket. The socket itself is 12 point, however, I have not stripped any bolts yet. If they can increase the length and make it 6 point, this would be perfect!
Mark S. West
Reviewed in the United States on January 25, 2018
Awesome little flip socket for using on my Milwaukee 1/4 inch hex driver. Great for use on all the Toyotas that I work on that have 8mm, 10mm, 12mm & 14mm as primary fasteners for interior, plastic belly pans and engine compartment components. I had to buy a Snap-On flip socket to cover the 12mm & 14mm sizes because Sunex doesn't make one as far as I could tell. The only issue I have with the Sunex 80810 is not really with the socket at all, but the 1/4" drive extensions that must be used with it. The 8mm side will not accept a 1/4" drive extension that has the small raised ring at the base of the 1/4" square drive part of the extensions, so you must find ones that are basically straight from the drive portion to the hex portion of the extension. But GREAT little flip socket!
Recommended Products
