Your cart is empty.
Your cart is empty.Sunpro single gauge pod adds additional gauges to the vehicles a-pillar post quickly and easily for a clear view of engine's vital statistics. It has a length of 6-1/2 to 7 and is highly resistant to heat and ultra-violet radiations (will not warp or fade). It is made of Acrylonitrile Butadiene Styrene (ABS) plastic and has a custom fit and finish. These single gauge pods fits best to all 2" gauges. As they are universal they can be molded to fit almost any vehicles. It includes appropriate manual and mounting hardware.
Sinjintek
Reviewed in the United States on April 30, 2017
It works, was never really meant to be the most elegant solution ...great for a temporary setup for those who don't want to wreck the factory trim, or to be screwed into that weekend missile you aren't cosmetically concerned about
Richard Q Gough
Reviewed in the United States on June 29, 2016
Nice Product!
Michael Pirozzi
Reviewed in the United States on March 29, 2016
waste of money..
namenotyourbusiness
Reviewed in the United States on April 18, 2016
The price was right, but very difficult to mold into the shape needed.
K.T.
Reviewed in the United States on July 2, 2014
Good product!
michael Rasmussen
Reviewed in the United States on June 30, 2013
i am about to try to get it put into my car and i find it to be very nice due to the fact that it will make it easier to tell just how much fuel i have in the car
M.T
Reviewed in the United States on February 19, 2012
I m really happy i bought this, it is a wonderfull gauge pod. the gauge fits in it wonderfully. it is of very good quality, and its structure manages to make the gauge's data pop out, in order for you to see theme much easely. Thank you Sunpro, you are doing a wonderful job.
Richard W. Bump
Reviewed in the United States on October 26, 2011
This is a perfect fit for a Sunpro gauge; however, it is not as easy to mold as indicated in the instructions. After cutting about 1/2" off of each side, I used a 500 watt heat gun to mold it to the roof pillar of my truck. It takes a significant amount of heat to change the shape and to get a perfect fit, it may result in warping of the gauge opening on some roof pillars. I did not go that far, so I have about a 1/32" -1/16" visible gap where it mates to the roof pillar.
Recommended Products
