Shopping Cart

Your cart is empty.

Your cart is empty.

SuperATV Clutch Holder Tool for Polaris Models - Zinc Coated, Made From 4340 Hardened Steel

4.8 (8) Write Review
Free shipping on orders over $29.99

$64.95

$ 26 .99 $26.99

In Stock
  • Easy-To-Use
  • Zinc Coated For Durability
  • Made Of Heavy Duty 4340 Steel
  • Designed To Secure Polaris Clutches So You Can Remove Upper Housing And Spider
  • SuperATV has gone paperless: To access installation instructions for your new SuperATV product, simply scan the QR code on your invoice using any smart device (tablet, smartphone, etc.). No more paper waste - just instant, easy access to what you need.


Product Description

FEATURES

  • Designed to secure Polaris clutches so you can remove upper housing and spider
  • Easy to use
  • Made of heavy duty 4340 steel
  • Zinc coated for durability

Polaris Clutch Holder Tool

Use SuperATV’s convenient and easy-to-use clutch holder tool to help you take your clutch apart. Polaris clutches can be very stubborn when it comes to removing the upper housing and spider. The torque required is immense. So, we built a clutch holder tool to keep our clutches securely fastened in a vice while we wrench them loose. Our clutch holder is made of heavy-duty 4340 hardened steel and zinc coated for superior durability.

Polaris Clutch Holder Tool

Customer
Reviewed in the United States on September 22, 2023
I could not get my Sportsman 570 clutch to release after tightening the spider. So I used my clutch puller.It caused the threads to be smashed, rendering the tool pretty much useless. I could run a tap through it, but it's too far gone.
Anthony Rose
Reviewed in the United States on January 28, 2023
Tool doesn’t work, doesn’t hold the clutch. The clutch still turns no matter how tight you tighten it down. Poor design. I found out after I tried using the tool that the clutch it torqued at 190 pounds.
Cathy W.
Reviewed in the United States on September 8, 2022
Used on a Sportsman Polaris 550
Customer
Reviewed in the United States on March 27, 2021
Works great for servicing your Polaris atv clutch. The only issue I had, what when removing the clutch from the holder, the removal tool messed up the threads on the holder.
m sweeney
Reviewed in the United States on October 9, 2021
After reading other reviews about damage to the threads when using the puller bolt the easiest solution was to drop a 1/4 in carriage bolt down inside the hole to before sending the bolt down.
ellen limongelli
Reviewed in the United States on July 31, 2020
This product works exactly as it should! I was able to remove and reinstall my spider And torque to the spec 225 ft-lb. I was skeptical after reading the reviews but as I figured everyone of those people had a problem due to lack of knowledge and operator error. Before threading the bolt apply never seize to threads to properly lubricate. Get yourself a proper washer. Center bolt must be torqued to at least 95 ft-lb for proper holding. Polaris spider is left hand threaded don’t forget and last but not least you must apply some heat to melt the thread locker. I’m no Polaris tech but I did my research and that’s all it takes.
Customer
Reviewed in the United States on February 22, 2020
Couldn't do the job without it. Great tool
ryan
Reviewed in the United States on November 25, 2020
Used it for my 2017 RZR XP4 1000. I torqued it to 95 ft lbs, and it worked great. There were no slip ups, it did exactly what it was intended for.