Your cart is empty.
Your cart is empty. Please measure your saw as some Delta & Rockwell &Grizzly14" bandsaws has slightly smaller holes for the throat plate. If so some slight filing or sanding may be required.If you mind, please don't buy it.
Make sure your insert recess has the locating pin on the side, not on the rear.
use on 14" Band Saws and 24" Scroll Saws.2&1/2" X .100 thick Please measure your saws recess to ensure proper fit
They fit Delta, Rockwell, some Jet, Ridgid, Grizzly, and other imports.
IMPORTANT INSTALLATION NOTE: First make sure the lip of the hole is free from dirt. If a table alignment pin,is not tight or missing,often the blade mounting slot will close up some over time which reduces the insert hole diameter slightly. I tap a flat head screw driver into the blade installation slot a bit to wedge it open. That should spread the insert hole enough for it to fit
Ed J.
Reviewed in the United States on February 17, 2025
This was supposed to fit my Delta 14" bandsaw. It didn't. It was a bit too large. Be careful when ordering.
Mary K. Andrasko
Reviewed in the United States on December 27, 2023
They are made for a jet bandsaw with a 2.5" hole but the plate measure .2.528 diameter.
Customer
Reviewed in the United States on March 27, 2022
It didn't fit
Recommended Products
$11.99
$ 5 .99 $5.99
$26.51
$ 12 .99 $12.99
$49.90
$ 24 .99 $24.99
$58.86
$ 31 .99 $31.99