Your cart is empty.
Your cart is empty.Taprite 3741 Dual Gauge Beer Wine Soda Tank Mount Primary Co2 Pressure Regulator WARNING: THIS PRODUCT CONTAINS ONE OR MORE CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER HANDLING. Use this regulator on any Co2 Tank with a CGA-320 valve. Co2 tanks have a male thread (CGA-320), these regulators have a female thread. Double Gauge Regulators Measure PSI (Pounds Per Square Inch) only. The screw in the center is used to adjust the output pressure. CO2, Plug, Primary Soda Regulator, 1P1P, CGA320 Inlet, 1/4" Flare Outlet w/Check, 160 pound and 2000 pound Gauges
TJ S.
Reviewed in the United States on August 22, 2024
It's hard to find s co2 regulator that operates above 60psi. This one will take you to 130psi before relief valve opens. Unfortunately, I was unimpressed with 130psi flow into bottle. Definitely weaker than stock sodastream bottle. I modified the relief valve to not actuate until 180psi. Disassemble valve, a few washers and reassemble. The low pressure guage is maxed out and will probably get damaged. If it bothers me, I'll replace it. This regulator probaby maxes at 200 psi but haven't taken it that high. I love high carbonation. I think a few easy mods will get you close to stock system.
Win zaw Hein
Reviewed in the United States on June 9, 2024
Not working when I install it on my soda machine.I couldn't make return because the return period expired.
Claire bear 14
Reviewed in the United States on June 21, 2024
We needed this for our soda dispenser; it is very good quality and exactly what we needed.
jcref
Reviewed in the United States on October 6, 2022
Doesn’t hold pressure, reliefs at very low pressure
Stevie B
Reviewed in the United States on November 20, 2021
Needed a regulator for CO2 filling of RV tires at 125psiWorks well for this.I left the outlet valve closed and adjusted the relief valve tomake sure it would not released before 125psiThe pressure relief valve operated at 135psiThanks
Jose Luis Oliveira
Reviewed in the United States on February 15, 2019
Started to leak c02 thru gauge part of glass.
BillC
Reviewed in the United States on June 27, 2017
This guage is just OK. It works but the relief valve is no good. I can't get 60 psi without the relief valve leaking and leaking. It hisses whenever I raise the pressure above 52 psi. Above 54 it really leaks. Such a waste of CO2. I bought this to carbonate water and it is weak because of the leaking relief valve.I wrote earlier and got no reply. I'd like an exchange for a guage that works to 60 psi
Yield House
Reviewed in the United States on August 29, 2016
Awesome unit. I tried others from other manufacturers but most limited to 60 lbs and they can't reach 60 lbs due to relief valve going off below 60 lbs. I like highly carbonated drinks and this unit works perfectly and holds a steady 60 lbs. No leaks, easy install, and easy and secure adjustment screw for pressure. I have carbonated over 100 liters of water mixed with powdered flavors from Target in 2 liter bottles since I got this unit a few weeks back. Highly recommend both manufacturer and seller.
Recommended Products
