Your cart is empty.
Your cart is empty.Product Description
Tim Langdon
Reviewed in the United States on June 5, 2025
Doesn't fit my 2007 Taylor 314CE. Screwdriver too big as well. So pretty useless.
Ganesh bhamare
Reviewed in India on May 8, 2025
Does not fit at all to Taylor guitar truss rod
Brian G Labanowski
Reviewed in the United States on May 21, 2025
does Not fit either the truss rod nut nor the Philips screws that hold the cover plate on my Taylor guitar.
John Dion
Reviewed in the United States on May 19, 2025
It didn’t fit my Taylor, even though it says it does. However, the official standard Taylor one that I had to order thereafter did. Seems more like they measured the outside rather than the inside. They should NOT advertise it as fitting Taylor AND Amazon should NOT let them sell it as so. I’m quite sure that it doesn’t work for anyone. I chose it because it was half the price but basically threw my money away… waste of time and money. Didn’t ask for a refund but should.
Matt Aschkynazo
Reviewed in the United States on April 23, 2025
Works perfectly on my old Guild Slim Jim. Great buy fo the money.
Louis Brotman
Reviewed in the United States on September 19, 2024
Thus tool is needed to adjust the Taylor truss Rod. It works fine.
George
Reviewed in India on July 29, 2024
Not properly designed for taylor guitar. Not a match for taylor.
Javier & Ivelisse
Reviewed in the United States on February 27, 2024
I would give this a higher rating had it fit in the truss rod cavity. I’m not 100% sure if it’s the right size since I can’t use it. Not gonna return it though because I can probably use it on another instrument or for another purpose.
Mark
Reviewed in the United States on November 26, 2023
Works as advertised
JF
Reviewed in the United States on October 4, 2023
The wrench fits the nut perfectly, but the screwdriver side is too big for the screws on the cover.
Recommended Products