Your cart is empty.
Your cart is empty.
Coil Voltage: 12 VDC
Switching Current: 450 Amps
Contact Voltage: 80 VDC maximum
Insulation Resistance: 100 MOhm
Dielectric Strength: Between open contacts - 900 VAC, Between coil & contact - 900 VAC
Mechanical Cycle Life: 100,000 operations
Electrical Cycle Life: 20,000 continuous operations at 100A, 2000 intermittent operations at 450A
Temperature Range: ~40 to +55 deg C
IP Rating: IP67
Warranty: 5 Years
Customer
Reviewed in Canada on September 2, 2023
Put this on my auger . Was identical one to one that was in it . Worked when put it on in the shop . Went to unload first load of grain and quit working. Had to replace it with a new one from the dealer .
Chris
Reviewed in the United States on June 13, 2022
Used this to replace the old style solenoid pack on an older M8000 Warn winch. Works great!
stoney
Reviewed in the United States on May 18, 2020
as advertised....great quality....smooth sale & delivery
Calie Owens
Reviewed in the United States on February 12, 2018
Worked well on my 8274 Warn. Lots cheaper and better looking than the original 4 solenoid setup*Update* after a year and a half, it quit working, contacted Temco and sent my defective solenoid to them and they replaced it no questions asked under warranty, great folks to deal with
Kelly W
Reviewed in the United States on November 10, 2017
Used to replace one on my 9,500 winch. Only used once with no problems. I’ll update review after afew hard pulls.
Barry malcombe
Reviewed in the United States on October 3, 2017
Failed after first use
Customer
Reviewed in the United States on August 29, 2016
works fine BUT did NOT INCLUDE a wiring diagram indicating Battery + and - and motor output connections.....diagram on the unit just has terminal numbers which don't help./ Not hard to figure out bu8t really how about putting the info on the devfice.
Andrew J.Slousky
Reviewed in the United States on October 1, 2016
Did exactly what I needed it to do for less than one third the price of the oem sollenoid.
Willy J
Reviewed in the United States on November 17, 2015
I mounted a 3,500lb pull Harbor Freight ATV winch on my trailer for a recovery winch. The HF relay stuck the first time I tried to pull something heavy on the trailer. I was determined to find a relay that could handle the amperage draw from any winch that I decided to install in the future. TEMCo has a 250 amp unit which would probably be sufficient, but I purchased the 450 amp unit.I first thought it was defective because the shipping box was torn, 1 input circuit screw was missing and 1 was loose in the package, and the unit rattled like something was loose inside. Emails with TEMCo assured me that the rattling was normal and I tested the unit and it was ok. TEMCo is sending the missing screw but I had some from the HF unit.Wired it up and it works great. I'm still using the HF winch motor but will probably upgrade to a 9,000lb or 12,000lb winch in the future.Only reason that I'm giving it 4 stars are that there are no instructions with the unit. In my case, I just had to drill out the HF cable terminals for the larger terminals, make a longer ground to common strap, and connect everything up to this new relay.
Recommended Products
