Your cart is empty.
Your cart is empty.Product Description
Joe stolz
Reviewed in the United States on May 17, 2025
The grinder wheels wear quickly but it you are gentle it works
Whitey
Reviewed in the United States on May 12, 2025
You get what you pay for.Disappointing build quality; The guide screws vibrate loose and the provided diamond wheels wouldn’t sharpen a single fresh tungsten.I have another brand that uses a larger wheel and is an enclosed system. I have been using the same diamond wheel for over a year.
Rob
Reviewed in the United States on March 16, 2025
This tool does a decent job of grinding tungsten. It fits a standard Dremel tool, and generics fine. The only downside is the tungsten guides want to come loose from the vibration of the tool. Other than that it does what it's supposed to do and gives a nice grind to your tungsten.
Boothe
Reviewed in the United States on February 8, 2025
Opinions on the criticality of the grind angle on tungsten TIG electrodes are all over the board. But in my experience having a nice clean point with a consistent angle is the way to go. Keep in mind that I'm a bit OCD, so there is that. I installed this on a variable speed Dremel tool and tried it out. Key points: You have to get the mandrel for the diamond wheel good and tight in the collet or the depth will change on you affecting the angle of the tungsten point. Check the brass guide inserts and be sure they're tight before you do your first grind. They were loose on mine and all but one fell out on the second grind. I simply bottomed them out in the shell and made sure they were snug, but not excessively tight. Once I got everything tightened up and the diamond wheel set to the the correct depth this fixture worked like a charm! I've used it on 1/16" and 3/32" electrodes so far to both sharpen and cut them off. It worked exactly as advertised. I couldn't be happier.
Eric Seamann
Reviewed in the United States on February 27, 2025
Good quality
Garth Van Deslunt
Reviewed in the United States on February 24, 2025
this is a must have if you TIG weld. Attaches to any Dremel or othe rotary tool with a threaded housing.
Milan Radojcic
Reviewed in the United States on February 12, 2025
I didn't have much hope for this product.. I have a bench grinder that I just used for Tungsten, glad I can finally put a new wheel on that and use it for something else without breaking the bank.
Neil Bruner
Reviewed in the United States on April 27, 2025
The diamond wheels don't last long . I could get 3 1/16 rods done then had to replace the wheel. I got 1 3/32 done and the wheel was shot.
Recommended Products