Your cart is empty.
Your cart is empty.Product Description
This NorthBoat transom saver kit works on
Yamaha FourStroke 15hp-115hp,
Mercury (ProXS, SeaPro, FourStroke/ProKicker) 9.9-150hp,
Verado (V8+V6) 250hp-400hp (require 2 blocks),
Mercury Racing 300R-450R (require 2 blocks) + 60R,
Suzuki DF25A-DF115B (1 block),
Tohatsu 15hp-60hp (1 block),
Honda BF8-BF60 (1 block),
VMAX-SHO 90hp-115hp (1 block)
Evinrude E-Tech (H.O. + Inline) 25hp-130hp (1 block).
Single Ram system required for correct fitment.
This transom saver kit contains 5 inch transom saver and two 4 inch motor hydraulic steering cylinder locks
High Density EPDM Rubber
Made of high density rubber material, durable, easy to install, solve your outboard motor trailer problems
Easy and quick installation
This is an accurate design with extra internal recesses, a must have for your outboard
The complete set
Additional dual motor hydraulic steering cylinder lock for multiple use scenarios
Customer
Reviewed in the United States on September 21, 2024
Fit great and performed flawless over a 2300 mile round trip. Highly recommend
George
Reviewed in the United States on August 1, 2024
Suzuki, 30 horsepower.
Bryan Manzeck
Reviewed in the United States on September 14, 2023
Very easy to use than the other mounts! No crouching down with a bar to attach to the trailer and motor!
CJA
Reviewed in the United States on August 18, 2023
This is great for protecting your outboard motor during transportation. This is highly recommended compared to people using the built-in stand on the outboard motor. Seriously people, that built-in stand is not meant for transportation purposes.
Taylor
Reviewed in the United States on August 14, 2023
I trailer my boat pretty far at times, and the transom takes a bit of a beating from the roads. This should extend the life of my transom. I'll update this review in a few months to say how the rubber holds up over time and use.
Veal
Reviewed in the United States on July 23, 2023
The material feels a bit soft. It fits my Merc 115 as you would expect. It's compact and install easily. I am not sure about the durability because it feels a bit soft. Time will tell. I will update my review one I put some miles on it.
Tom M
Reviewed in the United States on November 20, 2023
I used these on my I/O Stern Drive and they supported the drive well. I use two on one side and could have used one more so that I could have two supports on both sides.
Recommended Products