Your cart is empty.
Your cart is empty.
TRX4M Axles, 109.6g Aluminum CNC Front & Rear Complete, +10mm Widen TRX4M Portal Axles with Lay-Down Servo Mount & Links for 1/18 RC Crawler Car TRX4M Upgrades
Features:
Brass CNC, Black coating
Diamond Differential Cover, Full of texture
Portal axles, providing sufficient ground clearance
Equipped with 2 different servo mounts
+10mm axles increase the width of each side by 10mm, increase total length by 20 mm
The entire axles have been extended, not just the dogbone shafts, which prevents the dogbone shafts from being overburdened
Come with Hardened CVD shafts, 12/24T axle gears, 12/22T portal gears, brass wheel hexes and nuts
Specifications:
Front and rear axles/sets
Color: Black, Silver
Material: Aluminum alloy(Axle Housing), Stainless steel (CVD shafts, servo rod),Carbon steel (output shaft/gear),brass (wheel Hex), plastic (ball head)
Axle Gears: 24T/12T
Underdrive Portal Gears: 12T/22T
Axle gear ratio: 3.67:1
Output shaft: 3mm
Steering angle: about 45°
Connector specification: 7mm, thickness (4mm)
Net weight: about 109.6g
Total Length: 132.5mm
What's Included:
1 set of the TRX4M Axles
Note:
Not compatible with stock TRX4M chassis as the lay lown servo mount is wider than stock.
Not compatible with stock TRX4M chaissis as the lay lown servo mount is wider than stock.
Not compatible with original TRX4M size dogbone shafts as the axle housings are 10mm extended per side.
Compatible with both and stock TRX4M upgrade parts: axle gears.
Josh
Reviewed in the United States on February 4, 2025
Look nice work ok really sloppy gear mesh really could use overdrive in front axle messaged manufacture to see if that might be available for purchased never got a response thats a bummer
LemonSourDiesel
Reviewed in the United States on January 19, 2025
The axles have a decent turning radius for being so wide. The internals are metal and bearings. There was a little "wet" in the portals but I did add grease to all of them. Very smooth and operate without noise. When combined with the Injura Flex Blades and custom links, you can make these guys TWIST! The photo is a 6x6 TRX4M chassis frame rails. I will be using the extra frame length and link mounting positions to build a vehicle recovery armature and winch.
James buck
Reviewed in the United States on April 4, 2025
Very bad experience with thesee portal axles most screws were loose and the slop in the front portal is alot alot needless to say the the fron went out on the first run smh
Recommended Products
$48.16
$ 22 .99 $22.99