Your cart is empty.
Your cart is empty.F17T8 120/277V 4 Lamp, F25T8 120/277V 4 Lamp, F28T8 120/277V 3 or 4 Lamp, F32T8 120/277V 3 or 4 Lamp, F40T8 120/277V 3 Lamp.
Sparky
Reviewed in the United States on February 2, 2023
They work as recommended!
James Bartle
Reviewed in the United States on September 6, 2021
Worked great as a replacement for my florescent light. Easy and quick to install.
Cecil... Scarborough, Ontario, Canada
Reviewed in Canada on November 7, 2019
Ballasts I ordered were unavailable Substitutescame as alerted to, installedworking fine. But time will tell if they lastthus four stars
BioPilot
Reviewed in the United States on July 27, 2017
With just a little electrical knowledge it was easy to wire the ballast. I went from two ballasts powering two lights each to this ballast for four lights. Over the last two months the lights are steady.
Israel S.
Reviewed in the United States on June 20, 2017
works as expected. a little thicker and wider than its phillips/GE counterparts
Prof. Ima Boomer
Reviewed in the United States on May 1, 2017
First thought when fixture would not light was a bad switch(es). Then when I thought that 2 switches in two locations could not go bad at the same time it occurred to me that it might be the ballast. My light is over 8 years old so I ordered this EXACT replacement on Amazon. It worked like a charm. First I laid out both new and old ballasts side by side. One wire at a time I spliced an old wire with the corresponding new wire. I used "butt" connectors which made the job easier and less bulky than wire nuts. I stripped the old wires about 1" and lengthened the new wires ends to 1". I then bent the wire ends in two (doubled 'em) so that when I inserted the wire into connector there would be more wire to crimp and it would be less likely to fall out than just a single strand. Just go color for color and position for position and you should not have a problem. Fortunately my light fixture came with 2 wire plastic "hot" clip connectors. So I saved the old clip and spliced the new wire onto the old clip wire and then plugged it in. Good luck.
David P Pierre
Reviewed in the United States on February 4, 2017
Regular market price but, it saves a trip to the store. It describes exactly how to wire it in in a simple diagram.
Spartan
Reviewed in the United States on October 7, 2014
The wires were too short and everything had to be spliced. It would have been nice to know how long the wires were beforehand.
D. J. H.
Reviewed in the United States on May 12, 2012
I wanted an exact duplicate of my failed ballast for ease of replacement, and that's exactly what I got. Quick ship, easy install (even for me), and works just fine.
Recommended Products
$59.97
$ 31 .99 $31.99
$39.99
$ 18 .99 $18.99