Your cart is empty.
Your cart is empty.iMonse Upgrade Aluminum Valve Covers Left and Right Compatible with 2003-2008 Nissan 350Z Infiniti FX35 G35 M35 VQ35DE 3.5L Part 13264AM600 13264AM610--Bolt-on not included
LunchBox_Elrod
Reviewed in the United States on March 31, 2025
Edit: I had to shave the tab on the back to get the throttle body to sit flat. Still close, but enough.First started on the driver side, and then noticed pretty quickly that the number 5 cylinder in the back was off. The ignition coil bolts in the same direction as cylinder 1 and 3, the problem is the mounting bracket for cylinder 5 needs to be opposite. I'm going to have to either lengthen the wires, but you don't like doing to ignition coils, adding resistance. Or I'm going to cut the wire sheathing open and see if I can gain about 3 in. Also in the photos you see the gasket it came with was just not sitting right. I ended up using my old gasket as it was in good condition. The gaskets that come with it don't fit to spec. I ended up using my billet aluminum oil filter cap, as this set comes with a plastic one, but honestly it's probably the best piece in this kit. I did an airbrush on the outside, because it was just solid red and it stood out too much, wanted to add some definition to it. The construction of the valve cover lines up enough to factory with the OEM gasket. The finish is okay, I can tell it's not the best paint. It's currently priced at $110, and I think that's over the top for this quality.
Michael
Reviewed in the United States on April 12, 2025
Covers bolted on without issue and lined up clean with factory specs. Aluminum's got a sturdy feel and a smooth coat that looks like it'll shrug off grime for a while. No hardware included, but most folks working on an old Nissan already have the tools and bolts ready.
Recommended Products
