Shopping Cart

Your cart is empty.

Your cart is empty.

USB 5V to DC 9 V Guitar Pedal USB Power Cable, Tip Negative(-) design, Max current 800mAh, Compatible for Most 9V Guitar Effects Pedals (Center Negative)

4.9 (7) Write Review
Free shipping on orders over $29.99

$8.99

$ 4 .99 $4.99

In Stock

About this item

  • DC Output: 9.0V; Max Current: 800mAh; USB Input: 5V
  • Connector Size: Tip negative(-) design, DC Jack 5.5 x 2.1mm, 1.5M/5ft power cord.
  • Plug & Play, it is really handy when travelling or outdoors, just power it with a 5V power bank and you can start running your 9V Guitar Effects Pedals(such as Boss, Korg, Zoom, Behringer, and etc)
  • Directly charge with a usb battery pack, never buy any 9v or AAA batteries or worry about one going dead.
  • Safe & Reliable, with built-in upgraded intelligent IC circuit, our voltage adapter provides your devices perfect protecetion from over-current, over voltage, overload or short circuit.


Product Description


Customer
Reviewed in the United States on February 6, 2025
Works really well. I use mine connected to a WORX USB power adapter, which uses the rechargeable batteries for leaf blowers, hedge trimmers, drills etc. I have several of the batteries. I used this cable plugged into a splitter and out to 4 pedals, powered them for over 4 hours and the battery level didn’t even drop a single light on the battery level meter. I hate trying to find another electrical outlet to power pedals, this solves that problem. I will be buying another one. Now, the BAD SIDE. I tried thus cable plugged into only 1 pedal, and the power adapter would shut off by itself because it didn’t sense enough power drain. I figure if need be I will plug a little USB lite into it to create a larger power drain. VERY HAPPY with it.
Rockin Realtor
Reviewed in the United States on January 22, 2025
Works great. It’s part of my routine when playing music, this is essential for powering my effects boxes
Hello from Seattle
Reviewed in the United States on September 20, 2024
I bought this so I could hopefully power my UA LA2A compressor pedal using the USB power port on the back of my Mesa Boogie Subway WD-800 bass amplifier. I don't need anything other than a tuner, compressor, and amp to get my bass tone, and I want to keep my compressor pedal sitting on top of the amp because I'm not interacting with the pedal at all. I also didn't want to have to plug in multiple power cables if at all possible.I was worried when I ordered due to the noise complaints others have had when using this with anything other than a power bank, but I am happy to report that there is no noise at all when powering my pedal with the USB power port on the rear of the amp. The pedal is digital and takes 250ma of power.
James E. Haynes
Reviewed in the United States on August 18, 2024
Recently bought a Behringer TD-3 and wanted to run it off of a powerbank. These cords work, seem durable, have sufficient insulation to avoid line noise, and come in at a fraction of the price of a synth-specific option. I suspect they will also work with most 9v effect pedals, as it worked with several in my collection.
lagarde
Reviewed in the United States on December 11, 2024
Mine is 12Volt instead of 9Volt. It works but not 9V
Christopher Bell
Reviewed in the United States on October 7, 2024
It arrived with the plastic part cracked.
DM
Reviewed in the United States on October 6, 2024
I've tried this on all my guitar pedals: Behringer, MXR, & JOYO. It works on all of them without issues. It's super handy because now I can use my phone charger power block to also power my pedals.