Your cart is empty.
Your cart is empty.Product Description
Specification:
- Material: Nickel Alloy Wire Wound Resistor with Aluminum Case
Reliable. Problems like the flush LED would have a perfect solution, or you can use it in any AC DC circuits, power supply, frequency converter, inverter, motor speed control, drivers, etc.
- The load resistor will get huge hot, please don't touch it when the resistor is working.
- The load resistor should be mounted on metal board, not on flammable board such as plastic board,rubber,paper,wood and etc.
- Not recommend to use it for Automotive repair or refit unless you have professional knowledge.
- We recommend a 30%-50% increase in rated power based on your actual load power and add a heat sink device when it is necessary.
Handi-Racker
Reviewed in the United States on July 8, 2022
Stopped that annoying backup alarm on Rav 4 hybrid. Wired it in place of the alarm.
Michael and louis
Reviewed in the United States on March 5, 2022
Great
Carlos Cabral
Reviewed in the United States on December 10, 2022
Product work for what I needed, very recommend.
LogiP
Reviewed in the United States on July 11, 2021
Perfect for replacing external vehicle proximity notification speaker (VPNS) in 2021 Toyotas to prevent warning from constantly alerting. Corolla hybrid in particular. Only experienced due to connectors and mounting holes being in flexible. Worked great and was able to create custom mounting. Also good price.
Negative459
Reviewed in the United States on October 22, 2021
Picked these up for load testing small amplifiers at 4 and 8 ohm loads. They measured spot on at 4 ohms out of the box. I have definitely exceeded the 25 watt rating for short periods of time with no issues, but I wouldn't recommend it for obvious reasons.
Jackie
Reviewed in Canada on October 20, 2021
They work to increase the impedance of speakers quite well
Jose
Reviewed in the United States on November 22, 2020
Installed on two 4ohm speakers to make them 8ohms each
Carlos Löwenbräu
Reviewed in the United States on January 24, 2020
I used these to bump up the impendence on some smaller car audio drivers (JBL GTO75T's (tweeters) and three sets of GTO20M's (two-inch midrange - yes, you read that right - "two-inch midrange") from their default 2Ω impedance, to obtain ~6.1Ω per driver. They were perfect for an amp rated stable at 8Ω. I used the larger 100W 4Ω resistors for the Fosgate mid-woofers and made sure to mount them either to the ABS or the metal doors - no factory plastics (just in case). I haven't felt them get even remotely warm, even when I have the system running at a higher volume for a length of time.The tweeters necessitated a custom bracket, which I was able to fashion from some scrap ABS utilizing a heat gun. It's not very pretty, but it was a perfect fit/solution.
Rudder2
Reviewed in the United States on May 13, 2019
It's a resistor what can you say other than it is doing it's job as intended. I upgraded my 1984 Onan 8.0kW MDKD GenSet to use a SX460 Regulator board from the old transformer regulator. The stater winding was 4 ohms too low for the new Regulator so I put this in series with it to up the resistance and it's been working great.
Recommended Products
$42.63
$ 21 .99 $21.99