Your cart is empty.
Your cart is empty. Infrared Illuminator Board Plate with 36 Leds for CCTV CCD Security Camera. Replace a Security Camera Led Board for your broken or worn out IR Led Board. Great performance without much energy consume. Very bright Infrared Led Board with 36 lights. built-in protection circuit against damaging the IR Led Board by high voltage.
G Chamberlain
Reviewed in the United Kingdom on July 4, 2021
I bought this to replace the IR board in my old analogue 960 cctv camera. Almost half the ir led's on the old board had expired and I was trying to source a replacement camera when I found this board. It fitted almost perfectly in place of the old one. I say almost, as the power socket is right on the edge of the board, as shown in the picture. The old one is slightly indented to allow it to sit inside the camera housing. I had to do a bit of judicious filing on the opposite side of the board to make it fit, but it did eventually and worked a treat. My old poorly camera is now working 100% again. I would heartily recommend this board.
The Amazing
Reviewed in Germany on October 13, 2018
Meine Platine kam aus China. Die Platine hat auf der Innenseite zwei Bohrungen, die perfekt auf das Raspberry-Kamera-Modul passen.Die Montage geht damit schnell und einfach. Zwischen Raspberry und Modul habe ich einen Spannungswandler geschaltet (Siehe Bild)Anbei noch das nötige Grundwissen:- GND ist Masse (meist "-" oder "schwarz")- +12v ist Spannungen (meist "+" oder rot)- am Spannungswandler ist ein Rad zum Einstellen der Spannung.-Die Spannung muss mit einen Multimeter geprüft werden- „in“ ist der Spannungseingang (Raspberry GPIO 5v)- „out“ der Spannungsausgang (IR-LED 12v)Sie können eine einfache Lötstation und ein einfache Multimeter verwenden. Ich habe auch nichts besseres.Das sollten Sie haben:* oder * * * * gehäuse
JC
Reviewed in Spain on June 8, 2017
Cumple su objetivo y es muy potente. Necesita una fuente de 12V para que funcione. Me gusta el sensor de luz que activa el infrarrojo a baja intensidad.
Neeta
Reviewed in the United States on May 10, 2016
Good illumination and bright. Inly problem was the 2pin connector at its back was hard to find
Manuel Gonzalez Puerta
Reviewed in Spain on October 30, 2016
Funciona bien correctamente.Lleva incorporado un sensor de luz y se enciende y apaga automáticamente, funciona a 12 voltios cc.
Willy C
Reviewed in Canada on July 28, 2015
Nice and bright!
John S
Reviewed in the United States on August 2, 2014
Works great and a good value.
radiohead4737
Reviewed in the United States on May 9, 2013
This is a very nice piece works great and shuts off just at the right lite level.I used it for a while then found a cheap camera with LED's in it and went to it for the ease of use I did use this one for a bit and t worked just fine very well priced and functional as well.I would suggest this unit for anyone needing extra lite also.
j
Reviewed in the United States on March 12, 2013
Had the larger IR L.E.D. on my cam , thought this might work well , but it was not enough for my needs
Recommended Products