Your cart is empty.
Your cart is empty. Specification:
Material : Spring Steel (60Si2Mn)
Finish : Chemical Blackening
Material Thickness : 0.8mm
Material Width : 8mm
Spring OD : 41mm
Expand Length : 1000mm/39.4inch
Inner Mounting Type : Hook
Outer Mounting Type : Hook
Package Content :
1 x Drill Press Spring
Description:
1.The drill press quill return spring is good replacement for many existing quill spring drill presses, this is the chrome housed spring that returns the quill to the top after you have completed drilling.Used to all kinds of vacuum cleaner coil spring, volume tube coil spring, safe coil spring and so on.
2.Chemical Blackening, the performance of the product form oxide film, isolate the air, prevent rust.
3.Pay attention to safe when installing springs. Do not loosen the wire of fixed springs! When installing, install the spring with a fixed wire directly into the spring , and the wire will slide out.
Naaman c.
Reviewed in Canada on November 21, 2023
Must include instructions
GB
Reviewed in the United States on August 5, 2021
It was a good product that shipped quickly. However, this one was too big so I had to reorder a smaller size.
Customer
Reviewed in the United States on March 4, 2021
Measurements in the description said 41mm width, was almost 43mm. Wouldn't fit in the 41.5mm housing of my drill press.
KTM
Reviewed in the United States on March 31, 2021
Snapped on first use.
Jason Lewis
Reviewed in the United States on March 29, 2021
I needed this part for a 41.5mm diameter housing. The part that came was 42.5 mm in diameter. This makes it basically useless as there's no easy/fast/safe way to wind the outside diameter down to the desired size... Let alone getting it into the housing afterward. For a $7 part it makes no sense to even try. So it's basically useless. They need to do a better job of QC.Aside from the size issue it looked well made, but a well made part that doesn't fit is less useful than a poorly made one that does.
ARTHUR A. SCOTT III
Reviewed in the United States on March 15, 2021
Worked perfectly!
Barry Milaney
Reviewed in Canada on January 7, 2021
Works just like the original spring2 thumbs up
Ken
Reviewed in the United States on September 11, 2020
As advertised
happydays
Reviewed in the United States on November 2, 2019
I bought this spring to replace the broken one on my Delta 17-956 based on the measurements alone. Delta and other retailers list this spring at $35, but were no longer stocked. The spring arrived after five days. As received, the spring is tightly wound and held by a wire around the circumference. Before removing the old spring, note the orientation of the spring in the housing.I was concerned that the tightly wound spring would unwrap wildly when the clamp wire was cut, so I added a smaller wire (radially) around the tightly wound spring and twisted tightly to secure it. Another wire was added around the spring at 180 degrees, ( think 3 o’clock and 9 o’clock ) and twisted tightly.With the exterior spring tab located into the housing, I clamped a narrow piece of wood across the housing to preclude the escape of the spring. Wearing safety glasses, I cut the wire around the outside of the spring and removed it. The two small wires I added, were then cut and removed.Reassemble on the drill press. Wear leather gloves while tensioning the spring, Or pay the band aid tax. The spring tang has sharp edges. DAMHIK.This spring fits and functions as well as the original Delta part.
Recommended Products
