Your cart is empty.
Your cart is empty.Product Description
Feature
The Push-to-connect end can be rotated 360 degrees even after installation, which is convenient to use and has good sealing performance.
Material
Made of plastic and brass, with high strength, good sealing performance and long service life.
Applications
Mainly used for air compression systems, vacuum systems, pneumatic systems.
Note:
1.Make sure that the cutting surface of the pipe is vertical. Please insert the tube into the bottom before use.
2.When inserting the pipe into the joint, it must be inserted into the end, otherwise there may be a leak.
3.After plugging in, try to pull the tube, if you can't pull it out, it means it has been connected.
4.When loosening the tube, first confirm that there is no pressure in the tube, and then evenly press the end cap to the bottom.
Nathan
Reviewed in the United States on March 9, 2025
Nonfunctional for 3D printing. ID isn't listed anywhere so you don't know that you're getting maaaybe 1.9mm for a 1.75mm filament so there's a ton of friction which extruders don't overly enjoy, and even a 2mm ID PTFE tube (which is less than idea for minimal friction, 2.5-3mm ID is definitely not compatible) is too big and causes the filament to get hung up in the connector. Would have been nice to be able to find this out before ordering, and this should NOT be advertised as 3D printer compatible.
Engineer
Reviewed in Canada on January 3, 2025
Great product and the quality was good. The price was just right. would purchase from the seller again
Matthew Foran
Reviewed in the United States on September 8, 2023
I ordered two of these (6pc each). Half the lot had a wide fitting body with rough threads and the other half had a small body with good threads.
Carl Santos
Reviewed in the United States on October 28, 2023
Great product and quality is excellent
Rob
Reviewed in the United States on January 5, 2023
Nice tight fit with zero leaks.
Recommended Products