Your cart is empty.
Your cart is empty.Product Description
High Voltage Version 320A Two‑Way Brush ESC with Brake Cooling Fan for Vehicle Ship Model Brushed Esc 12V Brushed Esc 3S-6S Brushed Esc 1/8
How to Use:
1. Connect to the power supply battery correctly, the red wire at both ends of the wiring board is the positive pole, and the black is the negative pole. (Or connect the standard DC battery plug male plug/T plug/banana plug)
2. Connect the red and black wires of the ESC output to the red and black wires of the car's 5 motors respectively
3. Turn on the power switch of the ESC. If there is no signal input at this time, the motor will emit a "beep~beep~beep" alarm sound. When the transmitter is turned on and the signal is normally injected, it will make a "do~la~mi" sound, which proves that the transmitting signal and the receiver ESC have been connected.
- Quality Material: The 320A Two‑Way Brushed ESC is made of high-quality plastic + aluminum alloy + electronic components, so it is enough for long time use.Multiple
- : Various functions, with control , low voltage , over voltage .Excellen
- t Performance: Fine craftsmanship, two‑way brushed ESC. A good and wise choice you should make.Found Au
- tomatically: The center position can be found automatically, and the product also has a heat sink, which is safer to use. Easy to
- Use Easy to use, without any professional requirements even though you are an amateur.
Specification:
Item Type: Two-Way Brush ESC
Material: Plastic + Aluminum Alloy + Electronic Components
Weight: Approx. 87g / 3.1oz
Model: 320 TD-005 ESC T Plug
Support Function: External Powerful ubec Function, Providing 5.6V Maximum 3A High Current, with Switch Function
UBEC Supports Voltage Input: 6--16.8V
ESC Forward Current: 600A, Backward Current: 320A
Voltage Range: Support 6-16.8V Voltage, With Backup Power BEC 2A
Battery Support: Ni-MH, Ni-Cd 6~12 Groups, Lithium Battery 2~4 Groups
Support Motors: Support Motors Greater Than or Equal To 8T
Package List:
1 x ESC
Note:
1. Manual measurement, allow 1‑3mm / 0.04‑0.12in error, thank you!
2. Due to the difference between different monitors, the picture may not reflect the actual color of the item.
Corey King
Reviewed in the United States on July 4, 2024
I picked up an old brushed motor rc truck that had no controler this is a great replacemeant speed control highly recomend them.
Jonathan
Reviewed in the United States on September 3, 2022
Plugged in to motor, turned on, started smoking and burning immediately. Made a loud pop noise then completely died. The fan still worked but the ESC was fried.
Ben Pauza
Reviewed in the United States on July 8, 2022
These worked for a bit but I had two of my three completely lose reverse. The reverse Half Bridge must have burnt up. I have motors that usually draw 40a at full power so I think the ratings they have listed are peak numbers and not continous.
spence123
Reviewed in the United States on December 14, 2022
Seemed to have great specs, cooling fan, up to 16 volts. I needed them for a 12v battery, and 550 brushed motor. I purchased 4, the first one just flashed the LED's and was otherwise lifeless, the tge second one burned up after a few minutes opwrating eith no load. The 3rd burnded up almost instantly leaving an acrid fog stinking up the house. I'm afraid to try the 4th unit. Extremely disappointed. Save your money the odds are not good with this product.
Aaron w.
Reviewed in the United States on April 16, 2022
Yes it worked, yes it Burt up. This unit I believe is rated up to 16 volts and I knowingly supplied 18 volts. I figured if the voltage was too high it would cut power, however it caught fire instead. I’m not mad because I dove into this with the intentions of excessive voltage. It did work for about 3 minutes. Your results should be better than mine if used as intended. It took out my servo also… but again my fault.
Recommended Products
$21.68
$ 8 .99 $8.99