Your cart is empty.
Your cart is empty.Heater core with copper tubes and aluminum finish. Due to dimensional weight additional shipping fees apply. Winnebago Industries part number 1039330-01-703.
sean
Reviewed in the United States on July 3, 2024
Works great and doesn't leak
Leonardo
Reviewed in the United States on May 28, 2023
1999 Winnebago Adventurer 34V diesel pusher.I was able to install this new heater core in a relatively short time with out removing the A/C lines as directed in the instructions. An hour out and two hours back in.Use the rubber plugs provided with the new core to seal any coolant in the old heater core after removing each hose. A small clamp on each heater hose spares the coolant and reduces trapped air.It was less expensive but paid a premium for shipping.It is a tad shorter than original and this will ease with the installation into the housing.The kit did come with 5 extra clips to replace corroded or lost clips. If I recall there are 16.A latex caulking is recommended to seal the two housing during reassembly. Latex allows for easier removal over a silicone.
Larry Scott Compton
Reviewed in the United States on May 13, 2020
Got this for my 2002 Winnebago journey good fit but nightmare to install had to tilt my cab forward to install
Recommended Products
