Shopping Cart

Your cart is empty.

Your cart is empty.

WARN 38330 Snow Plow Blade Protector: Skid Shoe with Round Threaded Shaft, 1 Pair

Free shipping on orders over $29.99

$30.74

$ 15 .99 $15.99

In Stock
  • Designed to work with WARN standard plow blades 37574, 38732, and 38121
  • Used to help prevent wear and tear on your plow blade
  • Replacement skids are zinc finished to resist rust and wear
  • The plow skid can also assist in plowing material off of gravel surfaces by floating the edge of the blade just above the gravel
  • Designed for easy installation


WARN 38330 Snow Plow Blade Protector: Skid Shoe with Round Threaded Shaft, 1 Pair


WNY Mom
Reviewed in the United States on January 23, 2025
These were an exact replacement of what we needed for the plow blade. They took less than 10 minutes to install. AND they were inexpensive.
James Morrow
Reviewed in Canada on November 2, 2023
Works as expected
Jeffrey Mc Dermott
Reviewed in the United States on January 15, 2022
They work well just wish lasted longer and normally have to replace once per season.
Customer
Reviewed in Canada on December 29, 2021
Good product horrible shipping delay
Clint Westwood
Reviewed in the United States on January 30, 2019
No problems with these plow pads. Will get back on how long they last. I plow a few rough driveways and they were showing early signs of wear. They fit my Polaris factory branded plow. Easy to install, took about 10 minutes. Fair price but they need to last and I will pay more for long lasting pads.
Jason Penny
Reviewed in Canada on January 23, 2019
Seemed great at first and the price was right, but fell apart after very minimal use. I've since made my own from hockey pucks which cost about $3 a side including the puck. They're holding up much better.
LH
Reviewed in Canada on October 24, 2018
Perfect. As described. Size is right. Nice and weighty. Should do the job for years to come
Bob
Reviewed in the United States on March 29, 2017
Not much to say. They are plow skids and they fit. Seem like decent quality.
Jason Hardie
Reviewed in Canada on January 12, 2017
Great quality product. Turns out to be useless for me as I did not read the specs and they were too small for what I needed. Perfect for ATV plow though!
Michael M.
Reviewed in the United States on December 22, 2014
These look to be well made and as advertised. They should work well on my ATV plow on my packed limestone driveway. Have yet to use them due to lack of snow so far this season.
Longscout
Reviewed in the United States on February 3, 2013
The skids fit easily into the previously drilled holes for the set of skids that had worn out. The new skids came with most of the needed hardware except for the much needed lock washers to prevent the nuts from backing off the bolts, which presented problems for installation: having to purchase such washers, which takes up travel time going and coming, and the money to buy them, of course. NOTE: Each set of skids (2) should come with appropriately sized nuts (2 per skid=4 nuts) and at least two appropriate lock washers. Amazon should take steps to ensure they are included for the future. The only other thing I have to say of any value to such a review is that, once the new skids are installed, should the user wish to adjust them to lift or lower the blade, s/he should be prepared to face a challenge: both installation at first and later adjustment requires to wrenches or other appropriate tools for each installation or adjustment, and the tilt of a blade can interfere with the proper use of the under side wrench and/or the top side wrench -- owing to the curve of a plow blade, whereas the mounting surface is flat and straight.
Sea Nymph
Reviewed in the United States on December 30, 2013
They work well with the plow and help keep the wear bar protected. Solid, easy to install. Shipped fast. Check your plow often to make sure the bolts stay tight. I have a 350' driveway of gravel and it is hard on blades and skids. Have to check the condition on all every use.
William B. Boyce
Reviewed in the United States on January 11, 2013
I plow my driveway with an ATV that has a 60" (5 feet) blade. My driveway is 900' long and has a good 35 degree (steep) grade. The driveway is dirt/gravel/crushed stone mix.I use diamond style chains on my ATV for extra traction, and like the wider plow because at an angle it will not get in the way of the front tires.I wore off one of the original plow feet within the first couple of snowstorms of this winter (2012-2013). I continued to use it with the nub, but it made much more noise and was rougher on the entire maachine.I have since ordered 2 sets of 4 each feet to keep in reserve and replace as needed.They are relatively easy to replace, but do not come with lock washers or lock-nuts, and I strongly recommend you go ahead and add lock washerr to these feet or they will become loose. The first time I plowed both feet became loose until I added the lock washers. Lock-nuts would also be a good thing.I did attempt to find other brands of plow feet to try.Bottom Line: If you have a dirt/gravel driveway buy a couple of extra feet to keep on hand in the event you wear one out or break one. They do keep the more expensive cutting edge of the plow up off the gravel just enough to not wear it down too much.The height of the feet can be easily adjusted with a couple of wrenches.I had my doubts about plowing my driveway with an ATV, but have since been readily convinced that I made the right choice. My ATV is also an excellent utility vehicle around the yard and use it often.I strongly recommend you keep an extra set of these feet handy. They will wear out and you will need to replace them from time to time! These feet are a lot less expensive than a new plow blade or the cutter portion of your plow blade!!